【正文】 nization yet. 對于尚無國際 /國家基準可追溯的非標測試設備，可由工程技術部負責制訂相應校準規程，校準規程須包括適用范圍、使用設備、追溯標準、校準地點、校準周期、校準方法、驗收準則以及發現問題采取措施等，校準規程編號、審批按 171。文件和資料控制程序 187。執行，校準規程須符合顧客要求。 For the nonstandard test equipment that has no applicable international/national standards, the Engineering amp。 Technical Department is responsible for formulating corresponding calibration specifications. The calibration specification should include the applicable scope, equipment in use, traceability standard, calibration site, calibration cycle, calibration method, and acceptance principles, as well as the actions in case of problems. The numbering and auditing of calibration specifications shall follow the “Document amp。 Data Control Procedures”. The calibration specification should satisfy the customer requirements. 測試設備的計量狀態標識按《檢驗、測量和試驗設備控制程序 》 規定執行，禁止使用未經標識程 序 文 件 Procedure Document 重慶英特空調有限公司 Air International Chongqing Co., Ltd. 文件名稱 (Doc Name)： 實驗室質量手 冊 Laboratory Quality Manual 版次 Ver 頁次 Page 發行日期 Release Date 文件編號 (Doc No)： AICQ/QP1002 B/0 3 8 20xx0110 的測試設備，如發現核準數據遺失或標準破壞時，應立即停止使用該臺。 The measurement status of test equipment should be labeled in line with the Inspection, Measuring and Test Equipment Control Procedure. It is forbidden to use the inspection equipment without labels. In case the calibration data is lost or the standard is destroyed, immediately stop using this equipment. 按《檢驗、測量和試驗設備控制程序 》 規定建立每臺測試設備的檔案，包括校準記錄、檢定證書、校準規程等。 Follow the “Inspection, Measuring and Test Equipment Control Procedure” and set up the historic records for each test equipment, including calibration record, verification certificate, calibration specifications, etc. 校準設備和測試設備需按 《 檢驗、測量和試驗設備控制程序 》 規定進行預防、搬運、儲存。 The calibration and test equipment shall be preserved, handled and stored in accordance with the “Inspection, Measuring and Test Equipment Control Procedure”. 測試控制 Test Control 由工程技術部編制各項試驗規程，其內容包括適用范圍、使用設備、試驗流程、試驗性能標準等，由工程技術部制定每臺測試設備的操作規程。試驗規程必須符合顧客要求（包括抽樣方法 ），并采取現行的國際 /國家標準，當使用標準以外方法時須征得顧客認可。 The Engineering amp。 Technical Department shall pile various test procedures, including applicable scope, equipment for use, test process, and test performance standards, etc, while formulating operation regulations for each test equipment is made by the Engineering amp。 Technical Department. The test procedures must conform to the customer requirements (including the sampling method), and the prevailing international / national standards shall be adopted as the test procedures. Approval must be obtained from the customer in