freepeople性欧美熟妇, 色戒完整版无删减158分钟hd, 无码精品国产vα在线观看DVD, 丰满少妇伦精品无码专区在线观看,艾栗栗与纹身男宾馆3p50分钟,国产AV片在线观看,黑人与美女高潮,18岁女RAPPERDISSSUBS,国产手机在机看影片

正文內容

外文翻譯--無線收發模塊-其他專業-文庫吧資料

2025-01-27 10:12本頁面
  

【正文】 lization, high frequency stability, when the environmental temperature between 25 ~ +85 degree changes, the frequency drift of only 3ppm / 176。 In the wireless radio, television, munications, remote control, telemetry and other devices or systems, in addition to the use of amplitude modulation (AM), but also widely used in frequency modulation ( FM). The following two main properties of modulation pared: 1. Antiinterference capacity The main advantage of FM is its strong antiinterference performance. The socalled antiinterference, and mainly refers to the input signalnoise ratio (SNR referred to as S / N) under the same conditions, the FM receiver output signal to noise ratio large AM receiver in the output signal to noise ratio. FM than AM and strong antiinterference system can be two reasons for the launch signal power system size for analysis. FM wave edge of the power frequency ponent is separated from the carrier out of power. MFM modulation coefficient the greater the number of its edges is not only more frequent, and the rate of increase, which means that power in the carrier frequency into power while the proportion of large, and the AM frequency wave power while the largest carrier only power equivalent to half (when the modulation Index MAM = 1 pm). Therefore, Bobby AM and FM wave can have a greater frequency of side power, which means that it is better able to overe the builtin channel or the noise and interference. Secondly, can receive signals from the parison between mediation and analysis. AM signal as a result of the information has been included in the amplitude of AM signal (amplitude modulation signal and the amplitude is proportional to), solution of the envelope detector calls (also called amplitude demodulation) can not suppress parasitic AM interference。由于中頻放大器設有自動增益控制回路,因此,它的增益可以設計得很高而工作十分穩壓,這就使得超外差接收機不論對強信號還是弱信號,都能做到基本相同的放大倍數,也正是因?yàn)椴捎昧酥蓄l放大器,它的信號放大倍數可以達到很大,也就使電路的接收靈敏度大大提高,一般可達到 左右,與超再生檢波電路相比,超外差式接收模塊,無論在接收靈敏度上,還是選擇性上都有很大的提高,在抗干擾方面更加顯著。 2 超外差接收檢波接收器 超外差式接收電路的工作原理和一般的超外差式收音機的原理相同。在無信號時,超噪聲電平很高,經濾波 放大后輸出噪聲電壓;當有控制信號到來時,電路諧振,超噪聲被抑制,高頻振蕩器開始產生振蕩,輸出信號。這個頻率選低了,電路的抗干擾性能較好,但接收靈敏度較低,反之,頻率選高,接收靈敏度較好,但抗干擾性能變差。而間歇振蕩又是在高頻振蕩的振蕩過程中產生的,反過來又控制著高頻振蕩器的振蕩與間歇。以上例子說明,這種無線收發器件直線傳輸性能較好,而繞射性能將大大降低。)這種模塊我們?cè)谑彝?空曠處曾試驗過,在 500 米處可以正常接收,然而運用在這里時,相隔5 個房間后就無法接收,實際距離大約在 30 米左右,這個環境的情況為:樓層高度為 米,所有的發射器件均安裝于封閉的包箱內。一般在開闊區最大發射距離約 800 米,在有障礙的情況下,距離會縮短,由于無線電信號傳輸過程中的折射和反射會形成一些死區及不穩定區域,不同的收發環境會有不同的收發距離。 DF 發射模塊最好能垂直安裝在主板的邊緣,應離開周圍器件 5mm 以上,以免受分布參數影響。 DF 數據模塊采 用 ASK 方式調制,以降低功耗,當數據信號停止時發射電流降為零,數據信號與 DF 發射模塊輸入端可以用電阻或者直接連接而不能用電容耦合,否則 DF 發射模塊將不能正常工作。當電壓大于 l2V 時功耗增大,有效發射功率不再明顯提高。 DF 數據模塊具有較寬的工作電壓范圍 3~ 12V,當電壓變化時發射頻率基本不變 ,和發射模塊配套的接收模塊無需任何調整就能穩定地接收。 DF 發射模塊未設編碼集成電路,而增加了一只數據調制三極管 Q1,這種結構使得它可以方便地和其它固定編碼電路、滾動碼電路及單片機接口,而不必考慮編碼電路的工作電壓和輸出幅度信號值的大小。特別適合多發一收無線遙控及數據傳輸系統。通過以上對兩者的性能及成本的介紹,網友必對兩者的情況有所了解,目前被廣泛運用的是調幅形式的收發組件,由于其性價比較高,同時生產也較為方便,因此對一些要求不是太高的場合來說,都采用了這種模式,因此本文中也重點對這種模塊進行介紹。 生產調頻系列器件其調試過程相當復雜 ,所以需要配備綜參測試儀、屏蔽室等昂貴的生產調試設備,調試設備的穩定 性直接決定產品的性能,還需要專業的技術工人。而調幅制發射機發射的是調幅信號 ,當 MAM=1時 ,最大發射功率等于平均功率 (載波功率 )的 4 倍 .若調幅發射機與調頻發射機的末級采用同一型號的功率管 ,均按最大功率估算 ,則調頻發射機發射出的功率是調幅發射機發射的平均功率的 4 倍。 由于寬帶調頻系統占用的頻帶寬 ,調頻只適宜在超短波以上頻段( 30Hz-30GHz)使用 .對于中、長波頻段(中波: 1000100m, 長波 10- 1 km) ,則采用調幅或單邊帶調制方式。由于調幅信號的信息包含在已調幅信號的振幅中 (振幅變化與調制信號的振幅成正比 ),解調用的包絡檢波 (也稱振幅檢波 )器無法抑制寄生調幅干擾;而調頻信號的信息則包含在
點擊復制文檔內容
法律信息相關推薦
文庫吧 www.dybbs8.com
備案圖鄂ICP備17016276號-1