【正文】 目的：確保該設備的安裝符合國家壓力容器安裝要求 合格標準：《壓力容器安全技術監察規定》 驗證程序：檢查相關文件，核對現場 檢查結果：內容設計要求現場檢查及結論備注材質20g管板安全閥 Mpa壓力容器檢測報告壓力容器產品安全質量檢驗證書力學檢驗報告焊縫射線檢測報告壓力試驗檢驗報告結論：執行人： 日期： 復核人： 日期： 目的：保證在正常工作時，設備不會出現漏電現象。④ 保護接地電路的連接點牢固，沒有意外松脫的危險。調試過程中進行測試。2. 規格（是否符合材料配置要求）3. 管路走向（檢測其是否符合施工圖紙要求）制冷管路（檢測時依據供貨單位提供的質量保證書）。1℃。3℃驗證程序：——將溫度檢測儀測溫電阻通過驗證接口放入樣品室內。合格標準：從室溫（20℃）降至40℃的時間不大于60min。合格標準：1℃/min驗證程序：按照凍干機使用標準操作規程操作，當板層加熱開始時記下當時的溫度和時間，當溫度升至50℃時，記下時間。驗證程序：按照凍干機使用標準操作規程操作，當冷凝器制冷開始時記下當時的溫度和時間，當溫度降至40℃時，記下時間。 驗證程序：——冷凝器制冷到50℃；——凍干箱加熱至35℃；——開啟真空泵/真空泵組，記錄開啟時間。合格標準：真空泄漏率為≤?m3/s 驗證程序：——按照凍干機使用標準操作規程在空載狀態下運行凍干機；——冷凝器制冷到50℃；——凍干箱加熱至35℃；——開啟真空泵； ——當達到極限真空度時，關閉真空大蝶閥保壓；——到達5Pa時開始計時，觀察真空度變化。連續干燥24小時，停機稱量平底托盤中的殘留注射用水的量，按照下列公式計算凍干機的最大捕水量。 真空保護：真空度設定為10~30Pa（可自己設定）,當真空度超出此范圍時將報警。檢測項目及結果：按鈕狀態實驗次數結論備注開關壓縮機1壓縮機2板冷閥1板冷閥2摻冷閥冷凝器閥1冷凝器閥2循環泵1循環泵2真空泵1真空泵2水環泵大蝶閥小蝶閥摻氣閥前箱進氣閥后箱進氣閥液壓泵板層上升板層下降溢流閥前箱進水閥后箱進水閥前箱出水閥后箱出水閥電加熱有限量泄漏(啟動)真空?qǐng)?bào)警消警操作記錄冷凍干燥在位清洗在位消毒趨勢曲線工藝報表報警項目有效性結論備注有效無效水壓力空氣壓力真空?qǐng)?bào)警高壓報警1高壓報警2油壓差1油壓差2熱保護1熱保護2收液1收液2超溫報警`結論：執行人： 日期： 復核人： 日期： 壓縮機組測試 目的：確認壓縮機組的各項性能符合設計要求 合格標準及驗證程序：依下列所示進行開機運行，觀察各相關參數的具體數值，并進行判斷檢測或檢查項目合格標準實測結果結論水循環系統冷卻水泵，冷凍水泵，冷卻塔風機運轉正常，水管及接口處不滲漏機組氣密性增壓試驗充氮?dú)庵林评涔苈分校婵赵囼?yàn)關閉制冷機通大氣閥門，開啟真空泵，停真空泵24H后，真空度下降不小于25 pa安全聯鎖系統冷卻水和冷凍水的壓力低于規定值時能進行報警并停止工作數據記錄：檢測方法檢測數據結論時間壓力讀數漏點增壓試驗真空試驗檢查結果：結論：執行人： 日期： 復核人： 日期： （模擬試生產） 目的：以模擬在正常生產情況下，凍干機能滿足凍干粉工藝要求 合格標準：產品質量符合國家藥品標準WS1－（X－064）－2001Z 驗證程序：依凍干機操作SOP，和產品的凍干工藝要求執行，記錄下運行時的相關參數，并對凍干后粉針進行全檢，共做三批。 the second part is the interpretation of the two fundamental principles of the revision of laws and regulations in the party。s leadership, to solve the masses of the people reflect a focus on the problem. The new revision of the code and rule , reflects the party39。 the third is banned terms and discipline law, both with the party discipline, disciplinary regulations repeat and Criminal law and other laws and regulations repeat。s eighteen, ten eight plenary, the spirit of the Fourth Plenary Session of the Eleventh Central Committee and General Secretary Xi Jinping important instructions on the revised low political criterion and Regulations , highlighting the ruling party characteristics, serious discipline, the discipline quite in front of the law, based on the current, a longterm, advance as a whole, with Bu Xiuding independent rule and rule . Main principle is: first, adhere to the party constitution to follow. The constitution about discipline and selfdiscipline required specific, awaken the party constitution of party passes party consciousness, maintaining the authority of the constitution. General Secretary Xi Jinping pointed out that no rules, no side round. Party constitution is the fundamental law, the party must follow the general rules. In early 2015 held the eighth session of the Central Commission for Discipline Inspection Fifth Plenary Session of the 16th Central Committee, Xi Jinping again pointed out that constitution is the party must follow the general rules, but also the general rules. the revision of the code and rule is Method in adhere to the regulations established for the purpose of bining rule of virtue is to adhere to the party constitution as a fundamental to follow, the constitution authority set up, wake up the party constitution and party rules the sense of discipline, the party constitution about discipline and selfdiscipline specific requirements. 4 second is to adhere to in accordance with the regulations governing the party and the party. The Party of rule of virtue de, mainly refers to the party39。s advanced nature and purity, to reflect the revised standards requirements. Members of selfdiscipline norms around the party members how to correctly treat and deal with the public and private, cheap and rot thrifty and extravagance bitter music, put forward the four norms. Party leader cadre clean fingered selfdiscipline norms for the leadership of the party members and cadres of the vital few, around the clean politics, from civil servant of the color, the exercise of power, moral integrity, a good family tradition and other aspects of the leadership of the party members and cadres of the four norms norm norm. The Party member39。s leadership and the party39。s eighteen years implement the spirit of the central provisions of the eight, against the requirements of the four winds and transformation for disciplinary provisions, reflecting the style construction is always on the road, not a gust of wind. In the fight against corruption out of new problems, increase the trading rights, the use of authority relatives profit and other disciplinary terms. Prominent discipline of the masses, the new against the interests of the masses and ignore the demands of the masses and other disciplinary terms and make provisions of the disposition and the destruction of the party3