某家用電器公司1101檢驗測量和試驗設備控制程序(文件)
【正文】 ality Department is responsible for the calibration of the inspection, measuring and test equipment as well as the analysis of the measurement system. 技術工程部對檢驗、測量和試驗設備的適用性負責。 All users should use the IMTE correctly and be responsible for the daily maintenance. 4 工作程序 Work Procedures 選購與制造 Purchase and Manufacture 質量部根據測試產品 /過程質量特性要求，得出最大允許的測量不確定度和儀器的環境條件，在此基礎上提出請購申請，寫明添置原因、用途、設備型號、規格、性能參數要求等，經管理者代表審核，總經理辦公室核準后交付采購物流部采購。 At the arrival of IMTE, the Purchase amp。 The Equipment Department shall set up the General List of Inspection, Measuring and Test Equipment, including the equipment name, specification amp。 The Quality Department shall conduct regular inspection per the Periodical Inspection Plan. For the inspection of IMTE beyond AICQ capability, the superior measurement authority may perform the inspection. 當檢測設備的檢定不能追溯到國家標準時，由技術工程部編制自行校驗方法，作為校準依據的技術文件，如檢具等。 All users should operate the IMTE correctly and be responsible for the daily maintenance to make the equipment stay in good order. 發現檢測設備偏離校準狀態時，應停止使用，并通知質量部對檢測過的產品、項目重新評定其有效性，并采取相應的糾正措施，追溯到不合格的產品按《不合格品控制程序》執行。 If the IMTE, after being repaired, cannot reach the standard of acceptance but can still meet the measurement requirement, it can be admitted to put in use subject to the approval of management representative. The IMTE that is not able to meet the measurement requirements should be scrapped. 報廢處理的檢測設備由設備部開具《設備封存 /報廢申請單》，總經理辦公室批準后報廢并銷帳。 The personnel working on measurement must attend related technical training and pass the qualification test anized by the technical supervision authority. Only those who have obtained the Measurement Inspector qualification certificate are allowed to work post. 測量系統分析 Analysis of Measurement System 對于在控制計劃 中提及的所有可重復性測量器具和系統均須按《測量系統分析參考手冊》每年進行一次測量系統分析。 b). Any deviated readings at the ti
公司管理相關推薦
鄂ICP備17016276號-1