【正文】 Special Function Registers retain their values until the powerdown mode is terminated. The only exit from powerdown is a hardware reset. Reset redefines the SFRs but does not change the onchip RAM. The reset should not be activated before VCC is restored to its normal operating level and must be held active long enough to allow the oscillator to restart and stabilize. Program Memory Lock Bits On the chip are three lock bits which can be left unprogrammed (U) or can be programmed (P) to obtain the additional features listed in the table lock bit 1 is programmed, the logic level at the EA pin is sampled and latched during reset. If the device is powered up without a reset, the latch initializes to a random value, and holds that value until reset is activated. It is necessary that the latched value of EA be in agreement with the current logic level at that pin in order for the device to function properly. Programming the Flash The AT89C51 is normally shipped with the onchip Flash memory array in the erased state (that is, contents = FFH) and ready to be programmed. The programming interface accepts either a highvoltage (12volt) or a lowvoltage (VCC) program enable signal. The lowvoltage programming mode provides a convenient way to program the AT89C51 inside the user’s system, while the highvoltage programming mode is patible with conventional thirdparty Flash or EPROM programmers. The AT89C51 is shipped with either the highvoltage or lowvoltage programming mode enabled. The respective topside marking and device signature codes are listed in the following table. The AT89C51 code memory array is programmed bytebybyte in either programming mode. To program any nonblank byte in the onchip Flash Memory, the entire memory must be erased using the Chip Erase Mode. Programming Algorithm: Before programming the AT89C51, the address, data and control signals should be set up according to the Flash programming mode table and Figure 3 and Figure 4. To program the AT89C51, take the following steps. 1. Input the desired memory location on the address lines. 2. Input the appropriate data byte on the data lines. 3. Activate the correct bination of control signals. 4. Raise EA/VPP to 12V for the highvoltage programming mode. 5. Pulse ALE/PROG once to program a byte in the Flash array or the lock bits. The bytewrite cycle is selftimed and typically takes no more than steps 1 through 5, changing the address and data for the entire array or until the end of the object file is reached. Data Polling: The AT89C51 features Data Polling to indicate the end of a write cycle. During a write cycle, an attempted read of the last byte written will result in the plement of the written datum on . Once the write cycle has been pleted, true data are valid on all outputs, and the next cycle may begin. Data Polling may begin any time after a write cycle has been initiated. Ready/Busy: The progress of byte programming can also be monitored by the RDY/BSY output signal. is pulled low after ALE goes high during programming to indicate BUSY. is pulled high again when programming is done to indicate READY. Program Verify: If lock bits LB1 and LB2 have not been programmed, the programmed code data can be read back via the address and data lines for verification. The lock bits cannot be verified directly. Verification of the lock bits is achieved by observing that their features are enabled. Chip Erase: The entire Flash array is erased electrically by using the proper bination of control signals and by holding ALE/PROG low for 10 ms. The code array is written with all “1”s. The chip erase operation must be executed before the code memory can be reprogrammed. Reading the Signature Bytes: The signature bytes are read by the same procedure as a normal verification of l