【文章內容簡介】
, etc. (for glass parts)扭曲, 波紋, 凹痕,氣泡, 針眼, 斑點, 臟, 刮傷, 缺口等 (玻璃部件)XX Deformed, damaged, scratched, dirty mark, broken, chipped, crack, dent mark, rust mark, burr, etc. (for metal parts)變形, 受損, 刮傷,臟,破損, 碎片,開裂, 凹痕,生銹, 毛刺 (金屬部件)XX Open seam, fabric defects, poor stitching, untrimmed thread end, etc. (for woven parts) chipped, crack, dent mark, rust mark, burr, etc. (for metal parts)開縫, 布疵, 車縫不良,線頭等 (織物部件)XX3Bar Code Verification 條形碼的核對S1Bar code can not be scanned條形碼不能被掃描XWrong bar code label is used錯誤的條形碼X4Function test功能檢查AAssembly test according to instruction manual根據說明書進行組裝測試S1Can’t or difficult to set up不能或難以組裝XBShear amp。 press point check剪切點amp。擠壓點檢查S1For table amp。 chair, 1. Distance between moving parts shall be less than 7mm or more than 18mm桌椅活動/相對移動部件的間距應小于7mm或者大于18mm2. Accessible tubular ponents, holes and gaps shall be less than 7mm ot more than 12mm.可接觸到的管子部件,洞,縫隙應小于7mm或者大于12mm3. For cabinet amp。 bed, distance between moving parts shall be less than 8mm or more than 25mm柜子和床活動/相對移動部件的間距應小于8mm或者大于25mmXCNormal function test (sit on chair)一般功能檢查 (需坐在椅子上)GIINo function or malfunction against reference sample and / or requirement of client功能喪失或失靈XDFlatness check on base/leg底座的平穩性檢查GIIPut the base/leg on a flat surface, unit shaking instability。將底座放置于光滑的平面上, 底部明顯晃動XEFor office chair, Gas lift bottom check after assembly。辦公椅氣桿與底座的裝配檢查S1Gas lift bottom does not enter totally on the base hole, and cause obvious instability on the chair. 氣桿不能充分裝入底座圓孔內, 導致座椅明顯晃動 X5Field Tests amp。 Data Measurement 現場測試及數據測量ASize of unit 產品尺寸3 samplesThe measured data is out of 177。5% tolerance測量出的數據超出177。5%公差范圍Fail the shipmentBWeight of unit 產品重量3 samplesThe measured data is out of 177。5% tolerance測量出的數據超出177。5%公差范圍Fail the shipmentCMoisture content test含水率檢查S1For European market: out of range 8%12%歐洲市場產品: 含水率超過8%12%For American indoor products: out of range 7%14%美洲室內家具: 含水率超過7%14%For American outdoor products: out of range 4%13%美洲戶外家具: 含水率超過4%13%XDSeat static load test, if applicable椅面靜壓測試, 若適用3 samplesFor European Indoor: 130kg , 10 minutes。 歐洲室內: 將質量為130公斤的重物放置于座位上10分鐘For European Outdoor: camping – 110kg , Domestic 160kg , Contract – 200kg , 30 minutes歐洲戶外: 將質量為XXX公斤的重物放置于座位上10分鐘XXX: 野營用110kgs。 家用160kgs。 公共場所使用200kgs注