宏達振動電機中英文對照說明書(完整版)
【正文】 t, process the axis again. 4. if it is loose, expand the bearing hole of the closure . If it is tight, process the bearing hole of the closure again. 5. fix the two sides closure or bearing cap even, wind up the bolt. 七、儲存與運輸 7. storage and transport 。the oil mass for the two rank motor is half than bearing’s cubage, the oil mass for the four or six rank motor is twopart than bearing’s cubage. B. 電機運行 46月小修一次，運行一年大修一次，小修清除機體的積塵、污垢，檢查電機繞組的絕緣電阻、接頭、地線、連接部位的緊固螺栓是否松動，及時排除隱患。 c. motor axis parallels the center of sieve. 24小時待一切正常后，方可投入使用。 1. Do not collide. 2. 安裝前應檢查地腳螺栓孔與底座螺栓孔是否相符。 The vibrating motor is made up by eccentric mechanism and three phase asynchronous motor。 environmental temperature of application is between 15 degree and 40 degree. 2．海拔不超過 1000米。 the motor is halt for three months or the motor is new, before use it we should check the insulating resistance(380V, more than ,660V, more than ).If the motor is in damp ,we should be dry it ,the temperature is more than 180 degree. 5. 地腳螺栓采用防松裝置， 以防螺栓松動，使電機損壞。 If the vibrant force is oversize, we could remove the shields in either sides of the motor, and adjust the angle of the eccentric blocks in either sides of the motor for adjusting the vibrant force.(the phase angle must keep in step).After the adjusting, fix the shield. 五．維護與保養 5. maintenance 1. 定期清除外殼灰塵，以改善散熱條件，但不得用水沖洗。 1. vibrating motor can’t store the open air place or damp place. 。 a. supply right amount of grease lubricant(molybdenum disulphide grease)。 b. symmetry for the center line of the sieve. C．電機軸線與篩體中心線平行。 vibrating motor applies to the place of no explosion prevention. It is currency vibration source, w
公司管理相關推薦
鄂ICP備17016276號-1