【正文】
換控制系統的沒有缺相 保護 ,不能自動進行反切換,以及故障和恢復正常時使用單一的音響提示等缺陷。 電源 U1 和 U2 主回路輸入端的自動開關 QF1 和 QF2 的主要作 用是過載保護及短路保護 。 3 用 PLC 實現智能雙電源的控制 三相缺相檢測采樣信號回路中 ,作為 U1和 U2的三相缺相檢測的開關量采樣信號的 KA1KA3 和 KA4KA6,其常開觸點分別作用于 PLC 的輸入端的 X0X2,X3X5。 能發出兩種有明顯區別的報警和提示音響效果。同理 ,對于三相電源 U2 的 A 相、 B 相和 C 相的缺相檢測 ,也各采用一個中間繼電器 KA KA5 和 KA6,分別接于電源 U2 主回路的 A2相、 B2 相和 C2 相并與零線 N 構成的單相回路 ,形 成 A B2 和 C2 三相的缺相檢測回路。電源 U2主回路通過交流接觸器 KM2的主觸點閉合與其負載 W2相聯接 。在電源恢復正常后能自動進行反切換 。 power supply U2 main circuit through the AC contactor KM2 main contacts and a load of W2 connected。 in the event of a failure and return to normal when respectively sends out two difference obvious alarm and prompt sound effects. It overes the shortings of low double power supply switching control system without phase protection, can automatically reverse switch, as well as fault and return to normal when using a single audio prompts defects. The control system has perfect function, reliable performance, simple circuit structure, low manufacturing cost etc... 2 Intelligent dual power supplies switching main circuit control With short phase protection double load dual power automatic switching control circuit. It includes a main circuit and threephase short signal detecting sampling circuit. The main circuit of the input power supply power supply U1 and U2, its output has two 濱州學院專 科畢業設計 (外文翻譯 ) 3 loads W1 and W2. Power main circuit of AC contactor U1 through KM1 main contacts and a load of W1 connected。能自動進行缺相檢測、 三相電流顯示 ,某一路供電電源發生故障時能自動切換到另一路電源繼續對負載供電 ,并發出聲光報警 。 電源 U1 主回路通過交流接觸器 KM1 的主觸點閉合與其負載 W1 相聯接 。 KA1~ KA3 的常開觸點分別作為 U1 的三相缺相檢測的開關量采樣信號 ,作用于 PLC的輸入端 ,作為編制 PLC的 U1三相缺相檢測邏輯控制程序時的輸入條件 。 控制電路采用電笛 (或蜂鳴器 )作為報警音響 (同時配以紅色信號燈 ),而恢復正常時采用電鈴 HA 作為提示音響。在 PLC梯形圖程序中 ,輔助繼電器 R1 作為三相電源 U1 的三相缺相檢測 ,其接通條件為常開輸入 X0,X1 和 X2 的 “與” 邏輯 。兩路三相電源的主回路中每一相均有電流表指示濱州學院??飘厴I(yè)設計 (外文翻譯 ) 6 各相電流的狀況 ,以配合控制電路的缺相檢測。 本控制系統具有功能完備、 性能可靠、 電路構造簡單、制造成本低廉等特點。 similarly, the threephase power supply U2 A, B phase and C phase lack detection, but also the use of an intermediate relay KA4, KA5 and KA6, respecti