【正文】 用鋼墊片調整。如果需要，在安裝調整時可在開關柜下面插入合適的墊片。KYN2812開關柜可以靠墻安裝，以節省占地面積，但如果條件許可，仍建議設計配電室平面布置時，按雙面維護考慮，使開關柜后蓋板到隔墻之間以及開關柜兩側到隔墻之間均留出適當?shù)陌惭b維修通道。 從包裝之日算起，超過保管期限時，包裝的保護功能可能會喪失，若還需存放，則要采 取適當措施。必須保持空氣流通以防腐蝕。No other dangerous environment infections.216。注意在移動過程中，不得有較重的撞擊與振動。如果需要中間存儲時，還要放入干燥劑，重新密封。.216。 吊車，叉車或人工起吊架。 可在手車和/或接地開關操動機構上安裝附加聯鎖裝置，如閉鎖電磁鐵，用戶在訂貨時應提出要求。 手車在試驗或運行位置而沒有控制電壓時，斷路器不能合閘，僅能手動分閘（電氣聯鎖）。低壓室側板上有控制線穿越孔，以便控制電源的聯接。The bus bar from one switchgear to the other switchgear is fixed with the bushing and the ramus bus .The ramus bus is connection to the main bus with the bolt, it needn’t any clip. All bus and the ramus bus are covered with pyrocondensation bushing. The panel of bushing and bushing are isolated between the switchgear and the switchgear. And it has the effect on supporting.電纜室（圖3/1）Cable partment（drawing 3/1）電流互感器和接地開關裝在電纜室后部。手車剛插入開關柜就固定在試驗/隔離位置，同時也可靠地聯接到開關柜的接地系統。卸下緊固螺栓就可移開水平隔板，便于電纜密封終端的安裝。開關柜靠墻或面對面安裝。If the ambient temperature is over top of the highpoint, must consider equalizing or limiting current capacity for the design of main bus bar and branching bus bar. Installation the aerator is favor of rejection of heat. 注意事項：Matters need attention：若開關柜運行地區的濕度較高，溫度波動速度較快且幅度較大，開關柜在這種氣候環境下運行，就有凝露的危險，因此開關柜在備用和運行狀態下，用戶應保證加熱器全天侯投入！但在大電流運行中，可以不投入。CMaximum日平均值不大于 +35176。If you have any further questions on this instruction manual, the members of our field organization will be pleased to provide the required information.53 / 53目錄頁碼1.總則6概述6標準和規范6工作條件6正常工作條件7特殊工 特殊工作條件7注意事項82技術數據8電氣參數8耐內部故障電弧性能9外形尺寸和重量103結構概述12基本結構12外殼和隔板13開關柜內的小室13防止誤操作的聯鎖/保護164運輸和保管20交付條件20包裝20運輸21交貨和中間保管225開關柜的現場安裝24安裝現場的一般要求24配電室平面布置基本方案24基礎25以配電室地板作為基礎25在混凝土地坪上的基礎框架26開關柜的安裝與拼接27母線的安裝聯接29電力電纜和控制電纜的聯接30接地銅排的聯接31安裝工作的收尾32目錄頁碼6 開關柜的運行37起動37準備工作37起動39開關柜的操作40斷路器手車40斷路器42接地開關43電纜室門44電氣/機械的指示/監控447維護45概述45檢查和保養46修理49一般性修理49更換元件49備件49 版權所有，禁止將本說明書的全部或部分，以任何形式提供給第三者。Only install switchgear and/or switchboards in enclosed rooms suitable for electrical equipment.確保由專職電氣人員進行安裝、操作和維護。Make sure that under operation condition of the switchboard the specified data are not exceeded.說明書應放在所有與安裝、操作和維護有關人員能方便地拿到的地方。The switchgear plies with the standards of IEC60298,GB3906,DL404 etc.開關柜外殼的防護等級為IP4X，當斷路器室門打開、手車移開時，防護等級為IP2X。The manufacture must be consulted in advance about each special service condition. Special service conditions are to be agreed on by the manufacturer and user. l 已考慮安裝場所的海拔高于1000m時，空氣介質強度的降低對絕緣水平的影響。開關柜及安裝的電氣元件見圖3/1。相鄰的開關柜由各自的側板隔開，拼柜后仍有空氣緩沖層，可以防止開關柜被故障電弧貫穿熔化。框架由合金鋼板拼裝而成，上面裝斷路器和其他設備。所有母線和分支母線都用熱縮套管覆蓋。對于濕度較大的電纜溝，建議用防火泥、環氧樹脂將開關柜進行密封。 VCB and earth switch in the OPEN position, you can move the truck from the test/disconnected position to service position. On this state, it is be able to move reversely yet(electric interlock). 216。Only the truck have been in the test/disconnected position or moved out, the earth switch is permitted to be closed (machine interlock).216。The packaging of switchgear may be adjusted according to request for specific conditions, such as navigation packaging or no packaging. Especially marine transport, the switchgear must be sealed in film even though it is packed in container, put appropriate drier in packaging for guard against damp. Transport通常由單臺開關柜組成運輸單元，例外情況下，可由開關柜小組或背靠背安裝的開關柜組成運輸單元。 聯接吊鉤的繩子和水平線之間的角度應保持在60176。 檢查到貨完整和損壞與否。請注意，所拆下的各個內六角螺栓應復裝在開關柜原處，并應檸緊。CRoom temperature which does not fall below 25176。 不能拆除或損壞包裝。Store the transport units in the place which is dry, protected from the weather and safe from damage.216。示意圖5/5供參考。開關柜基礎的施工應符合電力建設施工及驗收技術規范中有關條款的規定。Civil work construction should consider that the height of foundation channel beam is obligate, and a little allowance, figure 5/6 showing. Follow towards to frame width, builtin anchor steel board with distance at 1 m to 5 m. 基礎框架是由槽鋼及角鋼焊接組成的框架結構，框架的基本尺寸要求見圖5/6，對槽鋼的高度無硬性要求，可以選用[5號或[8號槽鋼。不允許。具體工程的基礎框架應根據設計部門按制造廠的要求繪制的圖紙加工。Wide enough channels should be stay between the switchgears and wall for that installation and running and servicing are more advantageous. The distance between double switchgears is advised to be not less than 2500 mm when the switchgears are laid facetoface between double lines. Foundation將開關柜安裝在配電室地板上的基礎框架或升高的輔助地坪上，是比較合適的。配電室應干燥、整潔、空氣流通，門能上鎖，以及事先做好穿墻孔和電纜溝等必要的準備工作。Check the humidity regularly on schedule till to erecting works start.具有適于航海包裝和內部包有保護薄膜的開關柜：Switchgears with seaworthy or similar packaging with internal protective film:216。 開關柜不能堆疊。A dry and well ventilated storeroom216。Note any short quantities, defects or damage in transit in detail and inform related organization in time.請注意，中間保管應放置在對開關柜和安裝材料沒有任何傷害的場所。 通知我公司現場服務工程師去參加開箱驗收工作。 吊繩應有足夠的承載能力，吊鉤開啟寬度應≥30mm。The assembled switchgears are still tested for leaving factory in accordance with IEC 298 or GB3906 except that it is checked in accordance with order form, thus verifying their correct structure and function. Bus bar, fastening piece and accessory are packed by oneself. Packaging 開關柜的包裝按具體情況的要求作相應的調整，如航海包裝或不包裝。The truck in the service position, control wiring plug have been locked, don’t be pull out.216。 斷路器和接地開關在分閘位置時，手車能從試驗/隔離位置移動到運行位置。蓋在電纜入口處的底板可采用非導磁的不銹鋼板，是開縫的，可拆卸的，便于現場施工。The truck can be moved by manual. The structure of the truck is made of the steel, the VCB and other equipments are installed on top of it. The arm of spring bush is installed on the pillar of the VCB，When the truck is pushed on the service position, it has the effect of electrical interlocking. The si