汽車catia_培訓教程-展示頁
2025-01-28 20:10本頁面
【正文】 the list to use the second guide curve as middle curve. Select a spine, and two tangency surfaces. Select two guide curves. You can enter one or two length values to define the width of the swept surface. c、 Circle type 圓弧形輪廓 Guide curve 3 Guide curve 1 Guide curve 2 Two guides and radius Center and two angles: Two guides and tangency surface Center and radius Circle type 圓弧形輪廓 Guide curve 3 Guide curve 1 Guide curve 2 Three guides lines One guides and tangency surface Select a guide curves, a reference surface to which the sweep is to be tangent, and enter a radius value. d、 Conic type 圓錐曲線形輪廓 Five Guide Curves Three guides Four guides Five guides Swept Surface 掃描曲面 You can also specify anchor points for each guide. These anchor points are intersection points between the guides and the profile39。s plane or the profile itself, through which the guiding curves will pass. Two points: select anchor points on the profile which will be matched respectively to Guide Curve 1 and the profile is open, these points are optional and the extremities of the profile are used. Point and direction: select an anchor point on the profile which will be matched onto Guide Curve 1 and an anchor each sweeping plane, the default xaxis (which corresponds to the given oriented direction) is aligned with the two guide curves, from Guide Curve 1 to Guide Curve 2. If the profile is manually positioned defining anchor points will position the profile between the guides, matching the anchor points with guide intersection points, prior to performing the sweeping operation. 定位點可以控制羅廓線的位置和形狀（即按比例縮放），表明輪廓上哪個點和引導線相對應（當輪廓和引導線不相交時，且輪廓是封閉的） 在輪廓起始點處的 spine的垂直面與草繪平面的相交線通過輪廓的兩個端點時，不用設置定位點，否則需要設置定位點或手動定位輪廓線 Swept Surface 掃描曲面 With reference surface: Select a guide curve, a reference surface, and key in an angle value. The guiding curve must lie pletely on this reference surface, except if the latter is a plane. Adaptative Surface Swept 自適應掃描曲面 Guiding Curve Sketch designed in context Sketch 精度 斷面線的約束 Fill Surface 填充曲面 Boundary1 Passing Point Boundary2 Boundary3 Boundary4 Support of 2nd boundary Support of 4th boundary 與支撐面的連續性 Lo
教學課件相關推薦
鄂ICP備17016276號-1