【正文】 method: 1. Master carton drop test (1 master carton) Weight less than Kg cm height 1 corner/3 edges/6 faces on concrete floor or steel board 2. Individual drop test w/gift box cm height 1 corner/3 edges/6 faces on concrete floor or steel board 3. Bare car drop test Drop the car with full speed 2 inches height to have the 4 wheel hits the concrete floor or steel board (drop 5times) Run the car and observe if any gear broken or abnormal gear noise 4. Tape and rubbing test Use 3M810 scotch tape or rubber eraser on chrome plate, silkscreen, sprayed painted, and silkscreen letters. Apply 3 times Confirm no peel up problem occurs. RadioShack Cat Page 15 of 22 5. Impact test Run the car full speed toward a test field concrete wall (w/line and angle marked), Hits the concrete wall 15 times straight Forward and with various angles then hits 1 time straight backward 6. Gear reliability/durability test Stop wheel test, run the car on the flat concrete floor w/full speed apply the stop 20 times Do the FWD/REV gear shift to assure the reliability of the gear by applying the FWDREV gear change during the full speed running. 7. Jump test (Curb test) Run the car full speed out of the curb (5cm height) 5 times. Confirm no any damage on the car 8. Dirt and water exclusion test Run the car into dirt and water (run a pack full charged battery). No damage should be found. 9. Climbing angle test Have the Tank run up the slop (specified angle 35 degrees) 10. Battery patibility test Use RadioShack battery or Duracell and Energizer to confirm the battery fitness and patibility. 11. Reverse polarity test Have RadioShack and/or Duracell /Energizer batteries installed reversed 1 minute. Confirm the effect of the battery reverse protection (mechanically) Battery can?t be installed reversed at all or no current drain. 12. Transmitter a) Current drain at 9V to confirm the forward/reverse/left/right/stand by current 30mA b) Minimum operating voltage at 6V to confirm the transmitter can work properly. c) Frequency shift at ?%, or 49 MHz band frequency within MHz ?% 13. Receiver a) Make sure the unit works over 3 min. per charge. 14. Motor a) Current drain at on RX to confirm the Forward/ Reverse 750mA. b) Current drain at on RX to confirm the Left/Right Turret turn, current 100mA 15. Charger stand: a) Current drain at 9V in charge mode 1200 or 800mA. Phenomena amp。 RadioShack reliability test standard 2. Product Spec Remark: 1. One units from every 1000 units produced will be used to perform the test ***The remark must be strictly followed to assure the units picked cover the product from different time period*** 1. The test can be performed before RSCNQC?s inspection 2. The unit must be checked before it placed in the test and must be checked again through the ponent level after the test to assure the test did not damage or weaken the ponent. ***The remark must be strictly followed to assure no ponent had been weaken and damaged after the test*** Vendor performs following tests. RSCNQC will do the data verification only during inspection ? Storage hot/cold test ? Vibration test ? Driving motor/gears life test ? Continuous running test ? Track (Tire/wheel) durability life test ? FWD/REV slide trigger life test on TX ? L/R spin, L/R Turret, Cannon and Machinegun buttons life test on TX ? On/Off, Channel A, B, and C, Headlights, Hazard, Turn signal R / L switches, holder of battery door cycling test on TX ? On/Off, Channel A, B, and C switches on RX RadioShack Cat Page 14 of 22 ? Holder of battery door, battery door and Charge switch cycling test on Charger stand. ? Pulling force for Antenna cap/base on TX amp。 plating condition Pull the contact spring/plate gently 6. Confirm no sharp edge/point 7. Check battery type/polarity indication 8. Check the TX/Tank and Charger, no part adrift Pulling/Tapping/Shocking 9. Put a Tank onto a plug on the Charger 10. Press down “CHARGE” button on the charger for charging 11. Confirm “Red” LED to light up while charging and it goes off when the charge is finished after about 180 seconds. 更多免費資料下載請進： 好好學習社區 Page 12 of 22 12. Remove the Tank from the charger stand then power switch to “ON” on the car. 13. Have Tank run with the following 3 rounds。 correctly marked Type “9V” Confirm antenna can be normally screwed in/out and can hold vertically when fully extended. Confirm battery door can be normally taken off / replaced by using a Phillips screw driver. Confirm battery can be normally/firmly installed / taken off 更多免費資料下載請進： 好好學習社區 Page 10 of 22 Confirm On/Off and A/B and C channel switch works without intermittence Re: Power switch: On / Red LED as power indicator On / 0ff 510 cycles Operational check Confirm running speed meets spec km/h (Limit) Under fully charged battery and constant speed (1/3 sampled units) 5. Customer usage condition field test Outdoor or open field 5 rounds 1unit out of 1000 units Refer to for details 1. Run Straight line Angel deviation +/50 (TBD)cm / 1m 25 pcs. 2. Run L/R spin and figure 8