計算機網(wǎng)絡(luò)習(xí)題-資料下載頁
2025-01-10 08:15本頁面
【正文】 IP address of VLAN 1 must also be specified and must be in the same sub as the default gateway IP address. Finally, in order to remotely connect via tel to any Cisco device the password must e set or you will get a password required, but none set error message when you try to tel to it. 問題 14 得 0 分，滿分 10 分 Which of the following OSPF mands, when used together, will put the work (Select all valid responses) 所選答案： A. Router(configrouter) work area 0 正確答案： A. Router(configrouter) work area 0 D. Router(config) router ospf 1 反饋： The work mand specifies the IP address () followed by the wildcard mask (not the sub mask), and the area that is to be associated with the OSPF address range (in this case, area 0). The wildcard mask indicates in binary how much of the IP address much be matched with 0s indicating that the bits must match and 1 indicating that they may vary. Thus or indicates that any bit in the last octet can vary while all bits in the first 3 octets must match the work address (in other words, ) 問題 15 得 0 分，滿分 10 分 What will cause a TestKing router to enter setup mode? (Choose two) 所選答案： A. The configuration file is missing in NVRAM. 正確答案： A. The configuration file is missing in NVRAM. D. The setup mand was issued from the privileged mode prompt. 反饋： When router boots up, it checks the valid configuration into NVRAM and tries to load the configuration. If there is not configuration router automatically goes into setup dialog. From setup dialog, you able to configuration the basic configuration. 問題 16 得 0 分，滿分 10 分 What are the possible trunking modes for a switch port? (Choose three) 所選答案： A. Transparent 正確答案： B. Auto C. On D. Desirable 反 Here, the trunk link is identified by its physical 饋： location as the switch module number and port number. The trunking mode can be set to any of the following: onThis setting places the port in permanent trunking mode. The corresponding switch port at ...
試題試卷相關(guān)推薦
鄂ICP備17016276號-1