【正文】
about that sub. 問題 4 得 0 分,滿分 10 分 A TestKing Switch is connected as shown below: Which IOS mands should you enter if you wanted to link the router TestKing1 with switch port 1? (Select three answer choices) 所選答案: A. Switch(config) interface fastether 0/1 正確答案: A. Switch(config) interface fastether 0/1 C. Switch(configif) switchport mode trunk D. Switch(configif) switchport trunk encapsulation dot1q 反饋: Before you can begin, you have to get into the interface. Answer choice A is the only mand in the selection that puts the IOS into interface mode. Once in the interface you have to set it to trunk mode, so choice C is correct. 問題 5 得 0 分,滿分 10 分 Which interface mands would you enter on a Catalyst 2900 switch, if your goal was to bring all VLAN traffic to another directly connected switch? (Select the two valid responses) 所選答案: A. Switch(configif) vlan all 正確答案: C. Switch(configif) switchport access vlan all D. Switch(configif) switchport mode trunk 反饋: In order to pass all VLAN traffic from one switch to another, a trunk is needed. In order to configure a trunk on a 2900 series switch, only these two mands are required. 問題 6 得 0 分,滿分 10 分 What are the characteristic of link state routing protocols? (Choose all that apply.) 所選答案: A. The exchange of advertisement is triggered by a change in the work 正確答案: A. The exchange of advertisement is triggered by a change in the work C. Packets are routed based upon the shortest path to the destination D. Every router in an OSPF area is capable of representing the entire work topology 問題 7 得 0 分,滿分 10 分 Which of the following routing protocols are less likely prone routing loops and work reachability problems when used in discontiguous works? (Select all valid responses) 所選答案: A. OSPF 正確答案: A. OSPF D. EIGRP 反饋: Only OSPF, RIP version 2, and EIGRP carry VLSM information. In a discontiguous work, sub masks of different lengths can be us