【導讀】和反應來自處理器電子信號的驅動裝置將按照處理器編程設計來移動車輛。一輛自動推進遙控機器車輛包括了一臺車架裝置，最好是超外差接收器或是零中頻接收器。天線與天線之間最好有一定的間隔距離。最好的距離是25厘米或者更遠。接收的天線最好將一根調整到最高，一根調低，這樣2根天線就能保持90. 處理器最好能結合2個信號的接收信號強度指示器讀數。以及測量相位移來確定發射裝置的位置。

　　

【正文】 the aggregate of two measurements made from both antennae within a time frame of 20 [mu]seconds. 接收器可以是常用的超外差接收器或者是零中頻接收器。距離遠程接收器單元 4米的收發器的敏感度會在操作選擇的頻道上對遠程收發器單元傳送的信息區分進入的需要接收信號到 90Dbm水平。接收器會提供精確的 RSSI 模擬水平比例到接收信號的水平，此接收信號的水平是在 20∪ 秒的時間范圍內， 2根天線的測量總計。 The RTU transmits a narrow band signal on a given channel. The receiving antennas are set up with one antenna peak tuned while the other is dip tuned. The antennas operate 90 degrees out of phase. As a result there is a diminution in received signal strength from one antenna. The feeder coil on one antenna is cross coupled to the other antenna and vice versa so they are balanced. 遠程收發器單元在一個給定的頻道上傳送窄帶信號。接收天線是由一個調到最高，一根調低的 2根天線組成，這 2根天線成 90度的異相操作。結果就是從一根天線接收到的信號強度會減弱。一根天線上的供應器線圈會交叉耦合到另一根天線上，另一根天線也是這樣，所以 2根天線就平衡了。 The antenna signals are fed to separate receivers. The signals are bined for a summed RSSI reading and output from each receiver is also feed into a phase parator circuit which pares the phase of the two signals. The result of the parison is a range of outofphase measurements dependent on the RTU movement. An analogue signal dependent on the phase shift is then generated. 天線的信號會傳到分開的接收器。信號會組合成一個綜合 RSSI讀數，每個接收器的輸出也會提供給相位比較器線路來比較 2個信號的相位。比較的結果是根據遠程收發器單元移動的一系列異相測量。然后會生成基于相位移的模擬信號。 This signal is sent to the processor to calculate the angle of the RTU relative to the centre between the antennas. 發射到處理器的信號會計算遠程收發器單元與相關天線之間中心的角度。 Caddy Location system (CLS)球包車定位系統 The location system accepts analogue data from the caddy receiver which it processes on a continuous basis so as to be able to provide angular and distance location data in digital form to the system host controller. The signals are preprocessed (PLD processing) to provide the system host controller with an operational state. If the preprocessed signals indicate that the caddy is outside the desired distance, then the processor receives a default error signal thereby initiating a response by the caddy to reposition itself to its desired distance. 定位系統接受來自球包車收發器的模擬信號，進行持續處理后便能以電子形式向系統主機控制器提供角度和距離的定位數據。信號處理后提供給系統主機控制器的是一種運行狀態。如果處理的信號表明球包車在希望距離之外時，處理器就會收到系統設置的錯誤信號，球包車會作出反應重新確定位置到希望的距離。 The location system has a separate logical function that will take analogue data from the CAR system in terms of tone/phase and RSSI and convert it to positional data and send it on a continuous change basis to the caddy host control system (CHC) via a three wire serial bus. In the event that the analogue data is not changing, that is the RTU is not turned on or out of range then the CLS will send an RTU Off or out of range heartbeat to the CHC. Should the RSSI analogue data level rise above a set maximum for 1 meter then CLS will indicate to the CHC that a golfer with RTU enabled is present and has approached the Caddy within the minimum operating distance of meters from antennas. 定位系統有一個單獨的邏輯功能，會將來自 CAR系統的聲音信號 /相位和 RSSI的模擬信號轉化成位置數據并在不斷變動的基礎上通過三線系列汽車傳給球包車主機控制系統。在此過程中，模擬數據不會改變，遠程收發器單元沒有打開或在范圍之外時， CLS會發出遠程收發器關閉或范圍之外的律動給球包車主機控制系統。 RSSI 模擬數據水平升高超過預定的最高值 1米時， CLS會向球包車主機控制系統提示攜帶遠程收 發器單元的高爾夫球員在場且其正在接近球包車在距天線最低操作距離 。 Collision detection system. 碰撞探測系統 The requirement of the collision system is for the caddy to turn off before contact with a solid 。 Collision avoidance system 防撞系統 The collision avoidance system determines if any object of sufficient mass is in the path of the vehicle within a specified minimum distance and informs the host controller in the event that this occurs. The host controller will apply braking to the motion system such that the caddy will cease motion prior to a collision and that an indication is given to the player as to why the unit has stopped. 防撞系統會確定在一個確定的最低距離內車輛的道路上是否會有任何足夠大的物體，一旦出現就會通知主機控制器。主機控制器會在移動系統中運用剎車裝置，這樣在遇到碰撞之前，球包車就會停止移動并且會告知高爾夫球員為什么裝置會停止。 The key function of the Collision avoidance system is to ascertain when the vehicle is in motion or motion is intended if any object is in the intended path of travel at a distance of 1 meter or less. The detection process is performed by use of infrared (IR) CCD (charge coupled device) sensors which transmit a narrow beam width of IR wavelength light with a CCD sensor that looks at any reflections of its own signal being returned. From the angle at which it is returned the sensor is able to determine the distance from the sensor of the reflecting object. The sensor provides an output that is an analogue voltage representation of measured distance. Ten sensors are positioned around the caddy and can detect anything out to meters from the sensor. There is an outer band around the forward motion section of the caddy of meters and an inner boundary of meters. The side sensors are set with an inner boundary of meters. 防撞系統的主要功能是確定車輛正在移動或如果在車輛計劃通過的路上 1米或不到 1米的距離時存在任何異物時打算移動。探測過程通過使用紅外電荷耦合組件感應器實施，這些感應器會傳送紅外波長燈光的一個窄的波束寬度同時一臺電荷耦合組件感應器會觀察其自身信號返回的所有反射。從返回的角度，感應器就能通過引起反射物體的距離。感應器提供的輸出是測量距離的模擬電壓表示。球包車周圍會裝置 10個感應器，并能感應距感應器 。球包車向前移動的外圈為 ，內部界限為 。感應器側邊的內部界限為 。 The configuration of the IR CCD array can detect anything in field of view to the left, forward or right. Forward motion is conditioned on what the array has detected and influenced by the set rules defined in the programming. For example we can negate the caddy from turning into an object even if the object is between the RTU and the caddy. In the situation where the golfer walks past an object and turns sharply left, the caddy will continue forward until the object is cleared before allowing the left hand turn. 紅外電荷耦合組件陣列能探測場地視野里左邊，前面或右邊的任何物品。前方移動主要取決于陣列的探測內容以及編程設計定義的規則的影響。例如，即使異物在遠程收發器和球包車之間，我們也能防止球包車撞上異物。在此情形中，高爾夫球員跨過一個異物且突然左轉，球包車會繼續前進直到在左轉之前異物被清除。 The devices will not arbitrate function but merely report to the Caddy Host Control system if any object exists within a determined perimeter of each of the infrared CDD field of view. 如果在每個紅外電荷耦合組件視野范圍確定的周圍，此設備不會判定運