【文章內容簡介】 的拆除：Demolition the scaffold...........................................8五、注意事項：Notice proceeding.................................................................8一、施工地點:Job location ****化工區工業氣體二期管道設備保溫工程**** caojing HYCO1 STEP2 insulation project二、參照標準: Basis of piling JGJ1302001建筑施工扣件式鋼管腳手架安全技術規范《Steel pipe scaffold safety code of building construction with the fastener》三、材料標準：Material streamlined specification（一）鋼管：Steel pipe腳手架鋼管采用外徑48mm，橫向水平桿≤2200mm，其他桿≤6500mm，每根鋼管不應大于25kg。鋼管表面應平直光滑，不應有裂縫、結疤、分層、錯位、硬彎、毛刺、壓痕和深的劃道。鋼管的外徑、壁厚、端面等的偏差，應分別符合《建筑施工扣件式鋼管腳手架安全技術規范》（JGJ1302001）的有關規定。 external diameter of the steel pipe is 48mm, and thickness of pipe wall is horizontal bracing shall be less than 2200mm,others less than 6500mm,and every steel pipe shall be less than surface of the steel pipe shall be smoothness, and has not the crack, dogs ear, delaminating, burr and deep nick deviation of the steel pipe, as the external diameter, thickness of pipe wall, port etc, shall be accord the code 《Steel pipe scaffold safety code of building construction with the fastener》（二）扣件：Fastener扣件采用48型。扣件的類型包括：直角扣件、旋轉扣件、對接扣件、防滑扣件。腳手架采用的扣件，其材質應符合國家現行標準。 adopt the type of 48,and the types include the rightangle, circumgyrate, butt joint, and fastener of the scaffold shall be accord the GB code.（三）腳手板：Scaffold board腳手板采用木質，每塊質量不宜大于30kg。木腳手板應采用杉木或松木制作，其材質應符合國家現行標準。腳手板的寬度不宜小于200mm，厚度不應小于50mm，兩端應各設直徑4mm的鍍鋅鐵絲綁扎兩道。 scaffold’s quality shall be less than board shall be make of the fir or deal, and accord the GB width of the scaffold board shall be over 200mm and thickness over the ends with the 4mm galvanized wire fixing the board.（四）安全網：Protecting net 在腳手架施工操作面和護欄四周圍上防護網。It shall be laying safety netting on the operating platform and protecting 、施工工藝：Construction technique（一）施工準備：Preparations for construction工程負責人應按施工組織設計中有關腳手架的要求，向架設和使用人員進行技術交底。應對所有進場材料按規范進行驗收，不合格產品不得使用。經檢驗合格的構配件應按品種、規格分類、堆放整齊、平穩，堆放場地不得有積水。當腳手架基礎下有設備基礎、管溝時，必須采取加固措施。 project manager shall be show the regulations for technical operation on the operation worker, about scaffold in this the material must be check and acceptance, and no qualification no qualification material shall be stackup regularity and place shall be no it has equipment foundation, pipe duct under the base of scaffold, it must to be consolidation.（二）腳手架搭設的要求：Requirement of scaffold所搭設的腳手架要堅固、穩定，保證在施工期內及各種載荷和氣候條件下不產生變形，不傾斜、不搖晃，安全可靠。根據搭設空間，選用適宜的腳手架鋼管長度。必須有足夠的空間，滿足操作、材料堆放及行人的要求。作業層大橫桿間隔La/2m,小橫桿間隔不能大于縱距的1/2,。K201K202整體腳手架重大約16T, 施工人員上下可利用原有設施,作業平臺和施工平面須使用梯子上下。 scaffold must be firmness, the useful time, it must be no deformation, no inclination, no sway and safety on the kind of load and pipe of the scaffold must be select the suitable length by the building space, and the space must be enough to suitable for operate, material stackup and width of the scaffold shall be more than the operating lay, the big traverse bar shall be distance La/2m, and the small traverse bar shall be less than 1/2 of longitudinal traverse distance of vertical shall be less than , and longitudinal less than scaffold weight of the equipment K201K202 is about 16T,length about , width , and height about it’s building, the operating lay join the platform to reduce the worker may be use the device, when they up and down, but on operating lay must be use the 、立桿構造要求：Vertical腳手架必須調協縱、橫向掃地桿?？v向掃地桿應用直角扣件固定在距底座上皮不大于200mm處的立桿上，橫向掃地桿應用直角扣件固定在緊靠縱向掃地桿下方的立桿上。當立桿基礎不在同一高度上時，必須較高處的縱向桿向低處延長，與立桿固定，高低差不應大于1m。立桿接長除頂層頂步可采用搭接外，其余各層各步接頭必須采用對接扣件連接。 the scaffold build, it shall be harmonize the vertically and horizontally vertically pipe shall be fix the base with the rightangle fastener and less than horizontally pipe shall be fix under the vertically pipe tightly with the rightangle the vertical base is not on the same plane, it shall be extend from highness to lowness, and the gap shall be less than the vertical join each other, it must be use the butt joint fastener, but the 、縱向水平桿的構造要求：Longitudinal horizontal bracing縱向水平桿宜設置在立桿內側，其長度不宜小于3跨?？v向水平桿接長宜采用對接扣件連接，也可采用搭接。當使用木腳手板時，縱向水平桿應作為橫向水平桿的支座，用直角扣件固定在立桿上。 horizontal bracing shall be inside the vertical and length shall be more than 3 horizontal bracing may be use the butt joint or lap joint with the use the scaffold board, longitudinal horizontal bracing is the base of the transverse horizontal bracing, and fix the vertical with the rightangle 、橫向水平桿的構造要求：Transverse horizontal bracing主節點處必須設置一根橫向水平桿，用直角扣件扣緊且嚴禁拆除。主節點處兩個直角扣件的中心距不應大于150mm。作業層上非主節點處的橫向水平桿，宜根據支承腳手板的需要等間距設置，最大間距不應大于縱距的1/2。 central node must be set one transverse horizontal bracing and forbid two rightangle fastener of the central node shall be less than 150mm each transverse horizontal bracing of the other node on the operating lay which is not the central, shall be set base on needs, and the max distance shall be less than 1/2 of the 、腳手板的設置：Scaffold board laying作業層的腳手板應鋪滿、鋪穩。腳手板應設置在三根橫向水平桿上。當腳手板的長度小于2m時，可采用兩根橫向水平桿支承，但應將腳手板兩端與其可靠固定，嚴防傾翻。腳手板可采用對接平鋪或搭接鋪設。作業層上端部腳手板探頭長度應取150mm，其板長度兩端均應與支承桿可靠固定。 scaffold board of the operating lay shall be pave the all and scaffold board shall be lay on three transverse horizontal bracing, when length less than 2m, it may be use the two, but must fix on the scaffold board may be butt joint or lap ends of the scaffold board on the operating lay shall be