【正文】 縫處理技術?？芍踩肫胀ㄤ摻?，也可植入螺栓式錨 。 Has widely applied in had building39。該法簡單可靠，但容易損害建筑物的原貌和使用功能，可能并減少使用空間 。 Is suitable as well as is under the high stress, the high strained condition concretes ponent39。 作為水平提升干的函數的結果，原來的組件的部分由收到彎曲應力的特點變成了偏心受壓，因此，在加固，組件的配套能力，主要是在彎曲決定的條件下，原始組件的配套能力。s general method 1) Prestressed reinforcement law (1)Theprestressed horizontal tension bar reinforces concretes member in bending,because the prestressed and increases the exterior load the bined action, in the tension bar has the axial tension, this strength eccentric transmits on the ponent through the pole end anchor (, when tension bar and Liang board bottom surface close fitting, tension bar can look for tune together with ponent, this fashion has partial pressures to transmit directly for ponent bottom surface), has the eccentric pression function in the ponent, this function has overe the bending moment which outside the part the load produces, reduced outside the load effect, thus sharpened ponent39。 該法施工速度快，現場工作或不濕上只有少數濕抹灰工程等，對生產與生活的影響小，經過加強 的，是不顯著原有結構的外觀和原定清拆影響，但加固效果是決定由膠粘工藝和操作水平很大程度上，是在合適的承受靜態函數，而在正常的濕度環境是彎曲或拉構件加固。s situation the high temperature place。s outside, outside the Baotou Steel Factory reinforces reinforced concrete Liang to use the wet outsourcing law generally, namely uses the epoxy resinification to be in the milk and so on methods with to reinforce the section the construction mission to cake a whole, after the reinforcement ponent, because is pulled with the pressed steel cross sectional area large scale enhancement, therefore right section supporting capacity and section rigidity large scale enhancement. This law also said that the wet outside Baotou Steel Factory reinforcement law, the stress is reliable, the construction is simple, the scene work load is small, but is big with the steel quantity, and uses in above not suitably 組件的右側部分鋼筋的比例不太高的情況，增加了主要加固面積有可能提出的高原組件的右側部分抗彎曲能力，有效地支持。在原來的plateau ponent right section anticurved supporting capacity effectively. Is pulled in the section the area to add the castinplace concrete jacket to increase the ponent section, through new Canada partial and original ponent joint work, but enhances the ponent supporting capacity effectively, improvement normal operational performance. Enlarges the section reinforcement law construction craft simply, patible, and has the mature design and the construction experience。s function, its function is weaken inevitably gradually, our structural engineering39。 1 混凝土結構加固 混凝土結構的加固分為直接加固，并 加強間接兩種， 在設計時可根據實際條 件和使用要求選擇適宜的方法和必要的技術。s clearance, but similar existence construction wet operating time long shorting。適合偏低或有混凝土承運人等嚴重缺陷梁，柱受壓區混凝土強度的鋼筋。 Is suitable reinforcement which is insufficient in the concrete structure ponent oblique 溫場所 。s good and bad points with enlarge the method of sections to be close。 7）錨桿錨固法方 這項法律是在合適的混凝土強度等級為 C20的混凝土 ? C60的承重成員改造，加固，它已經不適合上述結構，素質結構，光認真適合很體面。s bining site transmits for is reinforced the ponent, has counterbalanced outside the part the load, changed the original ponent section endogenic force characteristic, thus sharpened ponent39。s （ 2）在鋼筋混凝土構件在使用前強調，要支持類型拉桿加固決定，形成一個由組件和加強支持下的復合超靜定結構體系的類型拉桿組成，下外荷載和預應力的綜合作用，在拉桿具有軸力，并通過與組件的結合的是增強了組件站點發送（未來支持和極端錨固點），已超出部分的負載反平衡，改變了原有構件截面內生力特性，從而激化組件的承載能力。s reinforcement transformation。屬于一種綜合技術由相關結構加固，上層建筑違背與上升重新定位以及放棄等部件拆卸組成技術，適合在有建筑物的加固改造 。s reinforcement divides into when the direct reinforcement and reinforces two kinds indirectly, the design, may act according to the actual condition and the operation requirements choice being suitable method. suitable for the brickingup structure direct reinforcement method 1) outside reinforced concrete superimposed layer 水防滲修補裂縫 要求等。 Is suitable in the column, the belt wall wall reinforcement。 適合于砌體式結構的間接加固方法 1）非結塊外包段加固法 該法屬于傳統的加固方法，其優點是結構簡單，現場的工作負荷和濕工作少，強調的是更可靠 。s stressful condition and crack factors and so on characteristic, determined that creates the 類似鋼結構的防護措施。s choice, should the reason which, the goal, the stress condition, the structure and the execution conditions needs to reinforce according to the structure, and considers the structure original connection method determination. The steel structure reinforcement general uses the welded joint connection, the friction high strength bold fastening suitably, has when the basis may also use the welded joint and the friction high strength bolt39。在修復之前，必須分析了裂縫的原因和影響的嚴重性，采取切實可行的治理結構的工作目標為導向或進行加固措施，對 不適合使用的維修加固的組成部分，應給予拆除更換 。當有成熟的經驗，也可使用其他加固方法。 砌體式結構構造性加固和修補 1）除了加強網 當網的設立不符合現行設計規范要求，無論是垂直的橫墻界面點咬搓有明顯的缺陷，誠信的房子時，無論是不好的，應該另外建立網進行加固 2）增設梁墊加固 當在大梁磚壁設置提出 了在部分壁球或大梁部分垂直分割，應加建梁墊進行加固。 Is suitable in does not allow to increase the original ponent section size, actually requests to enhance the section supporting capacity large scale the brickingup column39。 Is suitable in the brickingup wall reinforcement, sometimes also uses in outside the reinforced concrete when the superimposed layer reinforcement belt engaged colu