40米跨箱梁滿堂支架施工方案范文(文件)
【正文】 澆梁段頂板上，通過人孔、型鋼和鋼絲繩等將卷揚機固定。故在張拉完成之前模板能夠全部行走到位后。 ?、芗?xì)骨料：江西贛江產中粗砂。 箱梁混凝土澆筑 由于砼為整跨澆注，方量較大，澆注時間長，首跨澆注方量為408m3，標準跨每跨澆注方量為340m3。②砼初凝時間過短。頂板砼表面出現裂紋是由以下一種或幾種原因引起①澆注氣溫過高或風干現象嚴重造成砼表面容易開裂。箱梁內翻漿現象嚴重是由以下一種或幾種原因引起①砼坍落度過大。⑤砼澆注時氣溫偏低或雨天澆注。每一跨砼澆注時間為13小時左右，采用本方法澆注的砼，拆模后，外觀質量較好，沒有出現分層和冷縫現象，砼頂面沒有出現裂紋。如果采用水箱加水法進行預壓，建議在水箱底部設計若干滾輪或滾軸，以便2~3人就能推動水箱前移。如果采用大型鋼模板，建議在模板下方橫向工字鋼上設置滾輪，采用人工推動模板前移。 Four, the pledgor, mortgagor due to special reasons not to sign the contract, may authorize others to sign the contract and retained after the notary notarized power of Attorney (parties abroad, outside the territory of China sent or delivered by a power of attorney shall be certified by the notary public of the country, and certified by the Embassy or Consulate in the country). Agent required to audit mandates are clear, the content is plete (a power of Attorney sample record form five), whether the expiration date within PART_STORE_00102). Rule2 2nd set of goods was moved to the 2nd from the left the cage inside the vehicle Click on smart properties of oriented window screen to the right of [login rule] the period of validity, and audit the original identity card of the authorized person, and keep copies. Contracts signed by the authorized person authorized, in the signature bar marked authorized person, and signed by the authorized person39。 (B) a onetime debt。 more than a oneyear personal loan, extended term today added to the original term of the loan shall not exceed the maximum loan under the loan terms. apply in prepayment prepayment a borrower shall be in writing and, after it has been accepted。 (D) the payments are of equal value, equal installments on a monthly loan payment of principal and interest. Second, specific method of repayment in accordance with the relevant operational management procedures. roll over loans, according to the relevant business management approach of provisions, some personal loans approved, can apply for renewal。 Five, contract signing and client identity, signature, fingerprint is clear。 Second, loan person double charge and other parties signed a contract with the borrower and agent signature of contract?？傊瑑烧吒饔袃?yōu)缺點。 采用水箱加水進行預壓，表面上看加工水箱價格高，但由于其周轉次數多，所花勞動力少，多次周轉使用后，比采用砂袋碼砂進行預壓所花造價要低；且水箱加水進行預壓，工序簡單，施工進度快，比采用砂袋碼砂進行預壓要安全，值得推廣使用。 按照示意圖所示的澆注工序進行，有效地控制了每一層砼的澆注厚度，既有利于砼振搗，又有效地減少了底板砼的翻漿現象，同時有效地控制了每一次砼澆注后的布料間隔時間。③砼振搗方法不對，振動時間過長。③砼表面抹面不力，沒有修漿。④砼振搗不力，在每次補料前沒有將砼表面假凝層破碎。 由于其它標段的箱梁澆注均出現了不同程度的問題，如腹板砼冷縫及分層現象較明顯、頂板砼表面有裂紋、箱梁內翻漿現象嚴重。 ?、廾抗鄶嚢钑r間不小于90s。 四、混凝土施工 混凝土配合比的設計及要求 ?、倩炷翉?qiáng)度等級為C50 ②水泥：。為確保模板行走時不脫離行走軌道，將模板下方的橫向工字鋼通過鋼筋等卡在工字鋼軌道上。為確保外側模和翼緣模能夠順利行走，應確保模板脫離砼面不小于8cm。由于每塊模板面板均為平面，沒有按照箱梁平曲線設置弧面，故安裝模板時，確
公司管理相關推薦
鄂ICP備17016276號-1