附件一報告撰寫格式及樣本(已修改)
2025-08-09 10:31 本頁面
【正文】 1 附件一：報告撰寫格式及樣本 平面轉接器分析 主持人：陳俊雄 國立臺灣大學電機系 共同主持人： xxx (單位 ) 參與研究人員： xxx, xxx, … 摘要 本文介紹卓越計畫報告的參考撰寫格式。首先在第一頁內標明分項計畫工作項目 (或子項目 )的題目及參與人員，並撰寫中文摘要，中文部分請以一頁為原則，接著在第二頁起以英文方式描述該項目的報告內容，除 Title、 Authors 及 Abstract外，正文略含 Introduction、 Theory、 Results、 Conclusions、 與 References 等部份。字體中文為標楷體，英文為 Times News Roman，大小除工作項目名稱取 20pt，作者取 14pt，其餘正文均取 12pt，標題則以粗體大寫強調之。文書系統請使用 Microsoft Word，最後並應提供印出紙版及電腦檔案。版面設定為上下左右各留 3cm，紙張大小為 A4，頁次標示在頁尾中，標法請依分項計畫各工作項目 (或子項目 )頁次格式，如 1, – 2(或 ,)等。段落方面取 2 倍行高 (Double space)，段與段區不必再留額外 空白。圖表，下接其說明，但可置於文中或文後。印出的結果可參考底下所列印出的形式。頁數各工作項目 (或子項目 )以 10 頁為原則。 2 Analysis of Planar Transitions ChunHsiung Chen, YoShen Lin, and ChihWai Kao ABSTRACT Novel uniplanar 180o hybridring couplers consisting of coplanarwaveguide (CPW) rings and spiraltype phase inverters are proposed. In this study, CPW phase inverters with singlespiral and twinspiral type slotline short stubs are utilized to design the hybridring couplers. Specifically, two hybridring couplers with 33% (singlespiral type) and 40% (twinspiral type) bandwidths are implemented and examined, theoretically and experimentally. Keywords – Spiraltype phase inverter, 180o hybridring coupler. INTRODUCTION Hybridring couplers are fundamental ponents of microwave circuits such as balanced mixers, phase shifters, and feed works in antenna arrays. The ratrace hybridring coupler is the most mon one, but its area is undesirably large and its bandwidth is also limited due to the use of a 4/3g? line segment. In recent years, uniplanar transmission lines such as coplanar waveguide(CPW), slotline, and coplanar stripline are widely used in microwave integrated circuit(MIC) and monolithic microwave integrated circuit(MMIC). Uniplanar lines have the merits such as easy realization of shortcircuit end, no need for via holes, low dispersion, and easy integration with active ponents or lump elements. Using uniplanar line 3 structures, several 180o hybridring couplers have been reported [1][3]. In those papers, suitable wideband open circuits have been properly incorporated in the hybrid design, since the bandwidth of a hybrid is mainly determined by the performance of these open circuits. The si
公司管理相關推薦
鄂ICP備17016276號-1