機械專業畢業設計外文翻譯--極限與誤差(已修改)
2025-06-01 00:16 本頁面
【正文】 英文資料 Limits and Tolerances The breakage of the machine spare parts ,generally always from the surface layer beginning of .The function of the product ,particularly its credibility and durable ,be decided by the quantity of spare parts surface layer to a large extent. Purpose that studies the machine to process the surface quantity be for control the machine process medium various craft factor to process the surface quantity influence of regulation, in order to make use of these regulations to control to process the process, end attain to improve the surface quantity, the exaltation product use the function of purpose . The machine processes the surface quantity to use the influence of the function to the machine (A) The surface quantity to bear to whet the sexual influence degree of surface to bear to whet the sexual influence A just process viceof two contact surfaces of good friction, the first stage is rough only in the surface of the peak department contact ,the actual contact area is much smaller than theoretical contact area, in contact with each other the peak of the units have very great stress, to produce actual contact with the surface area of plastic deformation, deformation and peak between the Department of shear failure, causing serious wear. Parts wear may generally be divided into three stages, the initial stage of wear and tear, normal wear and tear all of a sudden intense phase of stage wear. Parts of the surface roughness of the surface wear big impact. In general the smaller the value of surface roughness, wear better. However, surface roughness value is too small, lubricants difficult to store, contact between the adhesiveprone elements, wear it to increase. Therefore, the surface roughness of a best value, the value and parts of the work related to increased work load, the initial wear increased, the best rough surface is also increased. Working hardening the surface of the wear resistance Processing the Cold Work hardening the surface of the friction surface layer of metal microhardness increase, it will generally improve the wear resistance. Cold Working but not a higher degree of hardening, wear resistance for the better, because too much will lead to hardening of the Cold Working excessive loose organization of metal, even a crack and peeling off the surface of the metal, declined to wear resistance. (B)The surface quality of the impact of fatigue strength Metal hand alternating loads of fatigue after the damage occurred in parts often Chilled layer below the surface and, therefore parts of the surface quality of fatigue very influential. 1. Surface roughness on the impact of fatigue strength In alternating load, the surface roughness of the Ausite easily lead to stress concentration, a fatigue crack, the higher the value of surface roughness, surface traces of Yu Shen Wen, Wen at the end of the radius smaller, antifatigue damage at the end of the more capacity Worse. 2. Residual stress, fatigue Cold Work hardening of the impact Residual stress on the impact of large parts fatigue. Surface layer of residual stress fatigue crack will expand and accelerate the fatigue damage the surface layer and the residual stress can prevent fatigue crack growth, delaying the formation of fatigue damage. (C)The surface quality of the corrosion resistance of the impact Parts of the corrosion resistance to a large extent depends on the surface roughness. The higher the value of surface roughness, Au Valley accumulate on the more corrosive subs
畢業設計相關推薦
鄂ICP備17016276號-1