【正文】 ccumulated pulse beat frequency signal, by the time the timer. In the running of the system can be observed through the indicator lights out, if even flicker that accurate measuring value. The system stops running, can display the total pulse number and time. After testing, the system works normally, meet the design requirements.The design of the infrared photoelectric sensor generates a pulse signal, after plastic surgery to enlarge, the input of SCM within the corresponding control, which measured within a minute of the pulse beat frequency, fast and convenient. Through observing the pulse signal, can check the health of the body, usually used for health centres and hospitals. The system can be used for measuring the pulse number of users, but also can set the upper limit of the number of times and, when the range of the measurement range over the set of drive buzzer alarm, but users can also set the alarm clock to remind the daily measurement, time can be set, the results were finally able to pulse signal acquisition to display on the . Keywords：STC89C52。本設計利用紅外光電傳感器產生脈沖信號，經過放大整形后，輸入單片機內進行相應的控制，從而測量出一分鐘內的脈搏跳動次數，快捷方便。系統停止運行時，能夠顯示總的脈搏次數和時間。系統以 STC89C52 單片機為核心，以光電傳感器利用單片機系統內部定時器來計算時間，由光電傳感器感應產生信號，單片機通過對信號累加得到脈搏跳動次數，時間由定時器定時而得。XXXX 本 科 畢 業 論 文 基于單片機的脈搏測量儀設計Design of Pulse Measuring Instrument Based on Single Chip學院名稱： 電子信息與電氣工程學院 專業班級： 111111111111111111111111111 學生姓名： 11111 學 號： 11111111111111 指導教師姓名： 11111111 指導教師職稱： 11111 2022 年 05 月目 錄摘要 ...............................................................................................................................IAbstract.......................................................................................................................II引言 ..............................................................................................................................1第一章 概述 ..............................................................................................................2 選題的背景和意義 ............................................................................................2 脈搏測量儀的發展與應用 ................................................................................3第二章 總體方案的論證與設計 ........................................................................5 主控模塊的選型和論證 ....................................................................................5 顯示模塊的選型和論證 ....................................................................................5 傳感器的選型和論證 ........................................................................................5 系統整體設計概述 ............................................................................................6第三章 系統硬件電路設計 ..................................................................................8 主控模塊 ............................................................................................................8 STC89C52 單片機主要特性 ..........................................................................8 STC89C52 單片機的中斷系統 ....................................................................12 單片機最小系統設計 ...................................................................................12 LCD 液晶顯示器簡介 .....................................................................................12 液晶原理介紹 ...............................................................................................13 液晶模塊簡介 ...............................................................................................13 液晶顯示部分與 STC89C52 的接口 ...........................................................14 信號采集電路設計 ..........................................................................................16 傳感器簡介 ...................................................................................................16 濾波電路 .......................................................................................................17 放大整形電路 ...............................................................................................17第四章 系統軟件設計 .........................................................................................17 系統軟件總體設計 ..........................................................................................17 程序設計原理 ..................................................................................................19第五章 系統調試 ..................................................................................................21 軟件調試 ..........................................................................................................21 硬件調試 ..........................................................................................................21 調試結果 ..........................................................................................................22 誤差分析 ..........................................................................................................22結論 ............................................................................................................................24致