真空吸塵器非正常運行的泄漏電流測試(編輯修改稿)
2025-04-21 06:33 本頁面
【文章內容簡介】 s with last calibration and calibration due date must be affixed to each instrument. 使用的所有設備都必須以一年的基準進行調校, 其調校日期和調校周期必須用黏紙黏固在每一個儀表上. The leakage current is to be measured between the (deadmetal parts)/(metal foil with an area of 10 by 20 cm in contact with the thermoplastic surfaces of the sample) and the grounded side of the supply source, and the control switch of the sample in “ON” position. 泄漏電流將在不帶電金屬零部件/馬達殼表面和地線之間測量, 在整個過程中, 樣機之開關應保持在 “ON”amp。2. Before the test, leakage test switching box’s all switches must be in “OFF” position. 測試前,檢查測試盒的所有開關應是在OFF檔. For this test, the sample must be isolated from the ground. 本測試,樣機必須于地板絕緣. Procedure/步驟: Obtain relevant number of samples of the appliance to be tested. 依據樣機適用條件準備有代表性的樣機數量來進行測試. Obtain Test Results Form TTR1006 and pletely fill in the information describing the sample and the equipment used prior to running the test. 用TTR1006測試結果的表格, 在測試操作前完整地填入樣機和使用的設備的情況. Abnormal con
環評公示相關推薦
鄂ICP備17016276號-1