變電所畢業設計外文翻譯-其他專業(編輯修改稿)
2025-02-24 08:12 本頁面
【文章內容簡介】 (about 2 to 5%). Since at noload the primary winding acts as a large reactance due to the iron core, the noload current will lag the primary voltage by nearly 90186。. It is readily seen that the current ponent Im= I0sinθ0, called the magizing current, is 90186。 in phase behind the primary voltage VP. It is this ponent that sets up the flux in the core。 φ is therefore in phase with Im. The second ponent, Ie=I0sinθ0, is in phase with the primary voltage. It is the current ponent that supplies the core losses. The phasor sum of these two ponents represents the noload current, or I0 = Im+ Ie It should be noted that the noload current is distortes and nonsinusoidal. This is the result of the nonlinear behavior of the core material. If it is assumed that there are no other losses in the transformer, the induced voltage In the primary, Ep and that in the secondary, Es can be shown. Since the magic flux set up by the primary winding， there will be an induced EMF E in the secondary winding in accordance with Faraday’s law, namely, E=NΔφ/Δt. This same flux also links the primary itself, inducing in it an EMF, Ep. As discussed earlier, the induced voltage must lag the flux by 90186。, therefore, they are 180186。 out of phase with the applied voltage. Since no current flows in the secondary winding, Es=Vs. The noload primary current I0 is small, a few percent of fullload current. Thus the voltage in the primary is small and Vp is nearly equal to Ep. The primary voltage and the resulting flux are sinusoidal。 thus the induced quantities Ep and Es vary as a sine function. The average value of the induced voltage given by Eavg = turns c h a n g e in flu x in a g iv e n tim eg iv e n tim e which is Faraday’s law applied to a finite time interval. It follows that Eavg = N 21/(2 )mf? = 4fNφm which N is the number of turns on the winding. Form ac circuit theory, the effective or rootmeansquare (rms) voltage for a sine wave is times the average voltage。 thus E = Since the same flux links with the primary and secondary windings, the voltage per turn in each winding is the same. Hence Ep = 7 and Es = where Ep and Es are the number of turn on the primary and secondary windings, respectively. The ratio of primary to secondary induced voltage is called the transformation ratio. Denoting this ratio by a, it is seen that a = psEE = psNN Assume that the output power of a transformer equals its input power, not a bad sumption in practice considering the high efficiencies. What we really are saying is that we are dealing with an ideal transformer。 that is, it has no losses. Thus Pm = Pout or VpIp primary PF = VsIs secondary PF where PF is the power factor. For the abovestated assumption it means that the power factor on primary and secondary sides are equal。 therefore VpIp = VsIs from which is obtained psVV = psII ≌ psEE ≌ a It shows that as an approximation the terminal voltage ratio equals the turns ratio. The primary and secondary current, on the other hand, are inversely related to the turns ratio.
環評公示相關推薦
鄂ICP備17016276號-1