機械專業文獻翻譯--微型模具成型的熱量和擠壓控制-文庫吧在線文庫
【正文】 range is )20 to 120oC. The symmetric design of the force transferring structure 機械專業中英文文獻翻譯 uniformly transfers the pressing force from the piezo element. This cylindrical force transfer mechanism moves in one direction and a planar surface keeps the shaft from rotating. A small sensor assembly was developed for our study in this paper. Displacement, pressure, and heat flux sensors pose the assembly. The displacement sensor measures the displacement at the moldcore extrusion mechanism where it presses the moldcore, and the displacement in the parting direction at the parting line. The displacement sensor is an eddycurrent type noncontact displacement sensor (SINKAWA Electric, VC202N) with range of 500 lm and resolution of lm. The above 1 axis force sensor served as the pressure sensor to measure the cavity internal pressure. The heat flux sensor measured the cavity surface temperature and the heat flux. A pair of thermocouples embedded at depths and mm enabled these measurements with the principle of inverse heat mounted the diameter mm heat flux sensors on the gate, cavity and sprue lock pin (Fig. 2). We placed one moldcore at the mold center. The microstructure was triangular grooves arranged with pitch 1 lm. The core surface had 32,768 triangular grooves with 140_ angle that are mm long on the perimeter of a mm circle. Fig. 2. Cavity details and moldcore The finished product formed into a 1 mm thick disk with diameter 12 mm. The core was made of steel (UDDEHOLM, STAVAX, 52 Rockwell hardness), with NiP plating. We cut the triangular grooves with an ultra precision NC machine (FANUC ROBOnano Ui). Two 12 lm deep air vent grooves were placed on the perimeter of the cavities. A vacuum pump pumped out residual air and gas from molten resin. To provide rigidity similar to a regular mold, we kept the entire 80 kgf mold size the same. For uniformly cooling the disk shaped product, we ran cooling water in a circular path. The injection molding machine (FANUC, ROBOSHOT a15) has a 機械專業中英文文獻翻譯 servo motor type drive with maximum clamping force of 150 kN. 3 Evaluating the injection press molding system Here are the molding conditions: Resin: Polystyrene, Resin temperature at injection: 190 oC, Mold set temperature:80 oC, Injection speed: 10 mm/s, Holding pressure:34 MPa, and Clamping force: 150 kN. Under these conditions,we pared the case with a constant
畢業設計相關推薦
鄂ICP備17016276號-1