【正文】 mm) through air or over surface. The insulation and clearances between that circuit and a higher potential circuit shall be in accordance with the requirements that are applicable to the higher potential circuit. 電壓不超過 50V時 ,現場接線端子的空氣間電氣間隙距離至少為 ，表面的電氣間隙至少為 ；其它位置的空氣中或表面的電氣間隙至少為 。F) higher than its normal operating temperature in the device, and not less than 65176。同樣見 。m) torque value. 例外：有原料壓成的接線板有厚度的最小要求，可以使金屬壓出內螺紋孔以配 合螺釘達到 2個全螺紋的要求，除非螺紋不符合 2個全螺紋。 The free length of a field wiring lead shall be at least 6 inches (152 mm). 現場接線引線的自由長度至少應為 152mm 13 WireBinding Screw Terminals接線螺釘 A wirebinding screw terminal is acceptable only for field wiring of a 10 AWG ( mm2) or smaller wire. The wire binding screw terminal shall consist of clamps or binding screws with terminal plates having upturned lugs or the equivalent to hold the wire in position. 接線螺釘只有 或以下時使用。 10 Wiring Terminals 接線端子 Terminal parts by which connections are made shall restrict connections from loosening even under hard usage. 接線端應避免松動或粗略利用。 d) Lug。 or c) The over surface spacings between the uninsulated live parts are at least 1/2 inch ( mm). 特例六：若沒有 CTI PLC 值或高于表 的要求值，則材料無需符合 I的要求，當 a) 材料符合高分子材料標準中指明的成品特殊電弧測試要求 電氣設備評估，UL746C b) 材料的 HVTR PLC 值不高于 1,或 c) 導電零件表面間距最小 1/2 inch ( mm) Table 略 Insulating material, including barriers between parts of opposite polarity or material, subject to the influence of the arc formed by the opening of contacts, shall be acceptable for the particular application. 絕緣材料，包括相反極性的零部件之間的隔 擋 ，可能受到 觸頭 斷開時 產生 的電弧的影響，應 可 用于特定應用。 Exception No. 1: A generic material with a Relative Thermal Index (RTI) as shown in Relative Thermal Indices Based Upon Past FieldTest Performance and Chemical Structure, Table of the Standard for Polymeric Materials ? Use in Electrical Equipment Evaluations, UL 746C that is not exceeded during the Temperature Test, Section 16, and is provided in such a thickness that damage does not result from tests required by this Standard, is considered suitable for the direct support of uninsulated live parts. 例外一：材料 具有相對熱指標 RTI,如基于先前現場測試、化學結構及表 所示高分子材料標準。 The requirements of apply to all housings and to all springs and other parts upon which proper mechanical operation may depend. It does not apply to small minor parts of iron or steel such as washers, screws, bolts, and the like that are not currentcarrying, or to other parts where the malfunction of such unprotected parts would not be likely to result in a risk of fire, electric shock or personal injury. Parts made of stainless steel, properly polished or treated if necessary, do not require additional protection against corrosion. 的 要求適用于所有封裝、彈簧 以及 其他 的 機械運轉所 必須 零件，而不適用于諸如墊圈、螺母 、 螺釘 和類似的 不載 流 小零件，或故障不至于 起火 、電擊、人 身傷害的其他零件。 本標準 所涵蓋產品之 零部件需符合的 標準參見附錄 A 。 SHUNT TRIP PROTECTOR － A protector with a trip mechanism energized by a separate source of voltage or current that may be derived from the main contact circuit or from an independent source. The trip mechanism may be either of the overcurrent type or the voltage actuated type. 分勵脫扣保護 器 ： 由另一 電流或電壓 觸動從而 脫扣的保護器，該電流或電壓 可以來自主接觸電路或獨立來源。 The acceptability of a protector in any particular application depends upon its ability to be used continuously under the conditions that prevail in actual service. Accordingly, for a particular application a protector may be affected by the requirements for the equipment it is used in, and it may be necessary to additionally evaluate features or performance characteristics that are not specified in this standard. 任意特定應用下的保護器 的 可接受性取決于其 實際 使用狀況下持續工作 的能力 。 Devices which ensure a manual restart due to the plete loss of voltage are covered by the Standard for SolidState Controls for Appliances,UL244A. 由于完全失去電壓而手動復位的的裝置，使用 UL244A。也可用手動方式斷開或閉合電路。 Specific ponents are recognized as being inplete in construction features or restricted in performance capabilities. Such ponents are intended for use only under limited conditions, such as certain temperatures not exceeding specified limits, and shall be used only under those specific conditions for which they have been recognized. 特殊部件是結構特征不完全或表現性能受限的。 除了 瓷 、酚類物質 或不對 載 流 部件 起固定作用的 材料， 其它都 應以實際運作狀況檢驗其性能，以此判定它有沒有所需的電 氣的 、機械 的 和 可 燃 的 性 能（除非用于特殊用途） 。 Exception No. 3: A material without an HAI PLC value or with an HAI PLC value greater (worse) than the value required by Table that plies with the Overload test, Section 17, Endurance, Section 18 and Dielectric VoltageWithstand, Section 19, need not ply with the HAI requirements of . 特例三：若沒有 HAI PLC 值或高于表 的要求值（該值符合 17 章過載測試，18 章耐壓測試， 19 章絕緣絕壓測試的要求），則材料無需符合 中對 HAI的要求。 Currentcarrying parts, including terminals, shall be secured to their supporting surfaces so that they are restricted from rotating or shifting in position when such motion results in reduction of spacings to less than those required elsewhere in this Standard. The security of contact assemblies shall be such as to provide for the continued alignment of contacts. 對載流部件，包括接線端子的支撐件應嚴格要求，不可使載流部件旋轉或移位從而造成電氣間隙減小至標準要求以下。 or g) Some other equivalent method. 表面之間的摩擦不應是唯一限制載流部件移動的途徑。 12 Wiring Leads 引線 Field wiring leads to be connected to a power circuit shall not differ from the wire size that would correspond to the rating of the protector by more than two sizes. The wire size shall not be smaller than 14 AWG ( mm2). 接于供電電路的現場接線引線，不應比保護器額定電流對應的線號大 2號。除非 預期接線為 或更小時，可選用 直徑的。 A multipole protector with one manually operated actuating member shall be so constructed that all poles make and break simultaneously, when operated manually or automatically. 有一個手動操作機構的多極保護器，在手動或自動操作時，應能使所有同時極通斷。