【正文】 The design shall also indicate the brightness, resolution and dimension and type of display frame (such as plane or spheric display) of display equipment. Equipment parameters shall be appropriately selected according to the operating environment. （如：高度、角度等），如包含復雜支架，需提供相關模型和完整CAD圖紙。視頻系統中所采用設備的說明書；Instructions of equipment used in the video system。The equipment room arrangement drawing shall include the plane layout and partial elevation of the power distributing cabinet and controlling box, giving clear indication of the trend of pipelines and trunking, explanatory notes, and so on. （2）平面圖上的設備位置、數量、編號，纜線規格、管線與線槽走向應與立面圖上的設備位置、數量、編號，纜線規格、管線與線槽走向相對應。On the system diagram, lightcurrent and smallpower equipment (such as microphones, sources of sound and audio processors) and strongcurrent and heavy duty equipment (such as power amplifier, active loudspeaker and passive loudspeaker) shall be distinguished with marks and notes in different colors. 系統圖中要求體現所有音頻設備的輸入、輸出接口形式，以便統計接口規格與數量。General engineering design instructions shall include, without limitation to: project profile, design basis, construction contents of each sub system, construction requirements and notices, special design requirements and key points in construction cooperation, technical interface requirements for the intelligent system and relevant disciplines within the scope of design, graphic symbols, and so on. List of equipment and materials 在材料表中的圖形符號圖例應采用國標，其次是部標、行標。IV. Provide the equipment data sheet of the soundreinforcement system (in EXCEL, with the format as follows。The equipment room arrangement drawing shall give clear indication of the installation position, correlations between equipment, and technical requirements of installation of the equipment inside the equipment room.（5）控制信號的強、弱電井布置圖應具體反映強、弱電井內所有線槽、管路、設備箱等的位置、尺寸The arrangement drawing of strong and weak electricity well of control signals shall specifically reflect the position and dimension of all trunkings, pipelines and equipment boxes inside the strong and weak electricity well.Detail drawing of installation安裝大樣圖是明確燈具安裝與建筑關系的說明圖。The pipeline wiring diagram of lightings shall indicate the No. of switch box from which the pipeline is drawn and the No. of loop, so as to check whether it coincides with the No. of loop of the switch box system diagram, and whether the total load connected with the loop coincides with that on the switch box system diagram. ，并盡可能與實際的排管布線方向一致。 when connecting the bined lights, the loop current shall not exceed 25A, and there shall be less than 60 illuminants。具體設計原則請參考《民用建筑電氣設計規范》JGJ 162008第8章。The light distribution box shall be placed in the place which is near to the lighting load center and convenient for operation and maintenance.（2）其他具體設計標準參考我國電影行業標準171。The lighting control switches in the areas directly serving the audiences, such as the entry, queue area, load on/off areas, performance area and rehearse area shall be intensively and independently controlled. 當采用調光設備時，每一照明回路的可載容量，應與所選用的調光設備的回路輸出容量相適應。 when neutral conductor is used in mon, its cross section shall be not less than 2 times that of phase conductor.。In making the system diagram of switch box, equilibration of the threephase system shall be considered。Drawing of lighting power supply and distribution system: With clear indication of the system structure, major configuration, terminal distribution, trunk cables, power supply requirements, explanatory notes, etc. For detailed principles for design, please refer to chapters 3 and 4 of JGJ 162008 Code for Electrical Design of Civil there are personnel participating in the stage show in likelytobe 5D theater with stage illumination involved, power supply and load calculation of stage illumination shall refer to the related regulations of Section , Chapter 9 of JGJ 162008 Code for Electrical Design of Civil Buildings.注意：Notes:,其電源變壓器宜采用接線方式為△/Y0的變壓器。當使用國標圖形圖例，又給予不同含義時也應加以說明，一套圖紙的圖例符號應前后一致。A plete set of drawings used in the design stage shall at least include the cover, drawing content, engineering design instructions and graphic symbols, list of equipment and materials, system diagram, and plan view.用于施工階段的圖紙至少應包括封面、圖紙目錄、工程設計說明及圖例、設備材料清單、系統圖、平面圖及設備的安裝大樣圖。(用EXCEL表格做出，格式如下，第一行內容為示范）；III． Data sheet of lighting (in EXCEL, with the format as follows。The drawing content shall include the following: project name, project ID, name of design corporation, discipline, drawing name, drawing number, sheet, drawing finishing date, the person who draws, and the auditor. Engineering design instructions and graphic symbols設計總說明須包括但不限于：工程概況、設計依據、各子系統施工內容、施工要求和注意事項、設計特殊要求和施工配合要點、設計范圍內智能化系統與相關專業的技術接口要求、圖例符號等。All plan views and equipment room drawings shall be attached with graphic symbols and quantity. Equipment and materials including puters, software, programming tools, cabinets, power supply and transformers shall be indicated in the drawings or list of equipment materials, with clear indication of the model, specification and total quantity.System diagram：應注明系統結構、主要配置、終端分布、主干線纜、供電要求、文字說明等。 it shall also indicate the model and specification of switches (or fuses), outgoing line loop No., and model and specification of leads, as well as the load capacity。Power connection of lighting equipments shall adopt the dedicated connectors and the rated capacity shall be enough.。采用共用接地裝置時，接地電阻值不應大于1Ω。 （3）燈控人員應能容易的觀察到觀眾席的情況；Lightcontrolling personnel shall be able to easily observe the auditorium。The electric wiring drawn from vertical shaft for lightcurrent and strongcurrent or control cabinet shall adopt trunking when there are numerous loops. ：水平線槽、垂直線槽。For details, please refer to chapter 8 of JGJ 162008 Code for Electrical Design of Civil Buildings and chapter 7 of GB 500342004 Standard for Lighting Design of Buildings.以下所述在設計時應特別注意：Special attention shall be paid to the following during design: 、編號、平面位置、安裝高度、安裝方式，管線、線槽走向、