【正文】
l multiples of it. Of course there also shift registers with an odd 9 number of bits. For example two cascaded 9Bit EEPROMs can store 18Bit data. If a SPI device is not selected, its data output goes into a highimpedance state, so that it does not interfere with the currently activated devices. When cascading several SPI devices, they are treated as one slave and therefore connected to the same chip select [5]. In figure 4 the cascaded devices are evidently looked at as one larger device and receive therefore the same chip select. The data output of the preceding device is tied to the data Ⅴ .SYSTEM TESTING Because munication between any two nodes may be tested through point to point, in this system Testing Process, munication model between node A and node B is a good example for testing schematic diagram, just like figure 10. Closedloop testing circuit is put up through PC with double serial ports and two RS232 ports and munication node A and B. On one terminal, data was sent through serial port testing auxiliary tool “serial port assistant ”, on the other terminal, returning data is monitored. Data is sent through PC’s serial port A, RS232 port, then data buffer and finally wireless transceiver module successively. However, the process of data receiving was SPI serial, data buffer, then RS232 port, finally PC. In t In this paper, a lowpowered and highperformance wireless data munication system were designed with the principle of transceiver nRF905 and 51 series of singlechip puter as the core hardware. An available solution to the wireless data munications was put forward, and this solution was good at stronger realtime response, higher reliability requirement and smaller data amount, which is widely applied various fields such as data munications, environmental monitoring and security Guard System. We believe that integrated and intelligent Communication Protocol are realized after software design is refined and improved testing process, digital oscilloscope was also used to monitor the data transfer of munication node A , node B , RS232 port and SPI port. In the following section, information from MOSI/SCK and MISO/SCK was analyzed to verify the system’s Correctness. As a waveform of wireless sending data, figure 11 demonstrate some relations among efficient data, address information and synchronous clock in wireless sending process. Because the receiver address must be designated by the transmit terminal, 4 byte address require to be sent after sending packet. Ⅵ .CONCLUSION In this paper, a lowpowered and highperformance wireless data munication system were designed with the principle of transceiver nRF905 and 51 series of singlechip puter as the core hardware. An available solution to the wireless data munications 10 was put forward, and this solution was good at stronger realtime response, higher reliability requirement and smaller data amount, which is widely applied various fields such as data munications, environmental monitoring and security Guard System. We believe that integrated and intelligent Communication Protocols are realized after software design is refined and improved systems to support asymmetric services by using directional antennas. 。data acquisition。 6 總結 4 在本論文中,根據以收發器 nRF905和 51系列單片機作為核心硬件的原理設計一個低功耗高性能的無線數據通信系統。提出無線數據通信一個可行的解決方案,這個解決方案適合于強大的實時響應,高可靠性要求和小數據量,被廣泛的應用于各種領域,例如數據通信,環境監測和安全保衛系統。在一個終端,數據時通過串口測試輔助工具 “ 串 口助手 ” 發送,在另一端,監控著返回的數據。接收過程如下:在接收方給數據源響應后將收到數據,然后會發送一個有效或無效的響應,直到收到拆除鏈路請求。在數據鏈