cisco2950交換機簡要配置手冊(文件)
【正文】 ive VLAN號 Step dynamic desirable—把端口設置為trunk如果對方端口是trunk, desirable, 或自動模式 interface interfaceid進入端口配置狀態Step舉例如下：Switch configure terminal Enter configuration mands, one per line. End with CNTL/Z.Switch(config) interface fastethernet0/1 Switch(configif) switchport mode access Switch(configif) switchport access vlan 2Switch(configif) end Switch配置VLAN Trunks命令 目的 Step7531 show vlan brief驗證Step no vlan vlanid刪除某一VLAN. Step命令 目的 Step注意 show vlan {name vlanname | id vlanid}驗證配置Step vlan vlanid mtu mtusize(可選) 修改MTU大小Step vlan database進入VLAN配置狀態Step show vlan {name vlanname | id vlanid}驗證Step mtu mtusize(可選) 改變MTU大小Step Step1 交換機必須配置成VTP透明模式當需要生成VLAN 號從1006到4094. 本交換機支持基于每一VLAN的生成樹(PVST)，最多支持128個生成樹。由于VLAN被看成是一個邏輯網絡，其具有自己的網橋管理信息庫 (MIB) 并可支持自己的生成樹 VLAN作為邏輯定義的網絡示意圖VLAN常常與IP子網相聯系，同一IP子網屬于同一VLAN。531show interfaces [interfaceid] description顯示端口描述show runningconfig interface [interfaceid]顯示當前配置中的端口配置情況show version顯示軟硬件等情況舉例如下:Switch show interfaces status Port Name Status Vlan Duplex Speed TypeGi0/1 connected routed afull a100 10/100/1000BaseTXGi0/2 wce server disabled routed auto auto 10/100/1000Base TXGi0/3 ip wccp webcache notconnect routed auto auto 10/100/1000Base TXGi0/4 notconnect routed auto auto 10/100/1000Base TXGi0/5 notconnect routed auto auto 10/100/1000Base TXGi0/6 disabled routed auto auto 10/100/1000Base TXGi0/7 disabled routed auto auto 10/100/1000Base TXGi0/8 disabled routed auto 100 10/100/1000Base TXGi0/9 notconnect routed auto auto 10/100/1000Base TXGi0/10 notconnect routed auto auto 10/100/1000Base TXGi0/11 disabled routed auto auto unknownGi0/12 notconnect routed auto auto unknown Switch show interfaces fastethernet 0/1 switchportName: Fa0/1Switchport: EnabledAdministrative Mode: static accessOperational Mode: downAdministrative Trunking Encapsulation: dot1qNegotiation of Trunking: OffAccess Mode VLAN: 1 (default)Trunking Native Mode VLAN: 1 (default)Trunking VLANs Enabled: ALLPruning VLANs Enabled: 21001 Protected: falseUnknown unicast blocked: disabledUnknown multicast blocked: disabled Voice VLAN: dot1p (Inactive)Appliance trust: 5Switch show runningconfig interface fastethernet0/2Building configuration... Current configuration : 131 bytes!interface FastEthernet0/2 switchport mode access switchport protected no ip address mls qos cos 7 mls qos cos overrideend刷新、重置端口及計數器Clear命令目的 clear counters [interfaceid]清除端口計數器.clear line [number | console 0 | vty number]重置異步串口的硬件邏輯Note53164 speed {10 | 100 | 1000 | auto | nonegotiate}設置端口速率 注 configure terminal進入配置狀態.Step見以下例子:Switch configure terminalSwitch(config) interface range fastethernet0/1 5 Switch(configifrange) no shutdown Switch(configifrange)*Oct 6 08:24:35: %LINK3UPDOWN: Interface FastEthernet0/1, changed state to up*Oct 6 08:24
醫療健康相關推薦
鄂ICP備17016276號-1