取水泵房安裝施工方案范文(文件)
【正文】 f rail transport and urban transport in other ways。s research program and research ideas. Technology reflects the various stages in the process, logical relations between various levels, research, techniques and phases. Network planning process the whole process can be divided into four parts, namely, background research, network architecture research, planning and implementation of research and programming interfaces. Figure Yibin city rail transit network planning technology roadmap planning interface is mainly responsible for network planning interface with followup planning tasks. Network planning Urban planning system in a transitional position, online network planning is pleted, will be carried out as soon as possible the following planning projects: 1, detailed control of the land of rapid rail transit network planning。科技，已成為我們走向高質量生活的一座橋梁，一根繩梯。四、主要人員安排a、專業電工5名，配套設備若干。b、 電氣設備和線路經調試合格后，動力設備才能進行單體試車。五、接地安裝施工時按照接地分項工程施工工藝標準《電氣裝置安裝工程接地裝置施工及驗收規范》（GB501692006）和《利用建筑物金屬體做防雷及接地裝置安裝標準圖集》（03D5013）進行施工。b、 開關接線應由開關控制相線，同一場所的開關切斷位置應一致，且操作靈活，接點接觸可靠。c、安裝完畢，測得各條支路的絕緣電阻合格后，方允許通電運行。e、 安裝完畢，應對接地干線和各支線的外露部分以及電氣設備的接地部分進行外觀檢查，檢查電氣設備是否按接地的要求接有接地線，各接地線的螺絲連接是否接妥，螺絲連接是否使用了彈簧墊圈，使接地電阻滿足設計要求。c、 母線安裝，柜（箱）的電源及母線的連接要按規范及國際通行相位色杯表示，相位應正確一致，保證進線電源的相序正確。b、 柜（箱）的固定，先按圖紙規定的順序?qū)⒐褡龊脴?biāo)記，然后放置到安裝位置上固定。電纜敷設后應盡快制作電纜終端頭和中間接頭，嚴格遵守工藝要求。e、電纜敷設時，在終端及接頭附近要有余留長度，直埋應在全長上留有余度，電纜的彎曲半徑
公司管理相關推薦
鄂ICP備17016276號-1