澳洲移民—土木工程cdr-wenkub
2022-09-02 09:04:15 本頁面
【正文】 the frame of the project organize was as follows:Fig. 1. Frame of the Project Organize Personal Workplace Activities Establish the calculation model.1. The chief structural engineer and I decided which structure system should be applied in this project, establish the calculation model for the puter analyzing and decide all the necessary factors. 2. In this project, according to the state structural design codes and the experiences of my work, following the feasibility of the economy and the technology, I decided to apply the frameshearwall system for this building plex. Generally to say, the two characteristics of structural behavior, respectively, involve resistance and displacement must satisfy the normal use conditions and the design codes. So, this kind of structural system has a good capability to resist earthquake action and wind force, it has a great rigidity and small displacement, at the same time, this kind of structure has a clear pressure transfer route, its design and construction technology is rather mature and we have a lot of relative experiences, that’s means the owner does not need spend extra cost on design and construction phrase. From what have been discussed above, the frameshearwall system is an appropriate system for this project plex. Calculation1. The calculation included: dead loads and live loads calculation, the whole bearing capability, earthquake action, resistance for earthquake force, wind load, floor displacement, and the reinforcing steel bar configuration, etc.2. The software I employed in this project were “PKPMCAD”a kind of finite element analysis, design and drafting software package which is totally according with Chinese structural design and construction codes, “ETABS”an integrated analysis, design and drafting of building software system developed by CSI, and MSExcel. 3. For some manual calculations, I employed MSExcel to get the result. I wrote some macrosheets to assist my work. This kind of calculation is very suit for the checking putations and designing some ponents, and it really had a good effect. For example, when I design a floor slab, it could make me calculate the slab very fast and convenient. Collate the calculation result1. Check the calculation result. After the puter assistant calculation pleted, I need to judge the result by some manual calculations and my prior engineering experience. If there was any improper situation, I would modify the correlative factors and the model or the sizes of the ponents to calculate it again, and feedback these amends to othe
環(huán)評(píng)公示相關(guān)推薦
鄂ICP備17016276號(hào)-1