【正文】
災系統的主要設施之一。通過對系統工藝的詳細分析,提出了對系統的控制 要求,確定了系統的控制方案。 關鍵詞: 排水, PLC,順序控制,備用 The design of subway drainage control system based on PLC Author: Yang Quanzhi Tutor: Ren Yanshuo Abstract The system for the subway drainage is one of the main facilities to the disaster prevention system and the drainage system. It’s important to vent seeper in the station in order to protect the subway system from be damaged. The system is controlled by the S7200PLC produced by Siemens and the digital expansion module EM223 with some Intermediate relay to replace the traditional relaycontact system, use the Soft control work wiring programmed by the PLC to pump the water from every pool and monitor the water level of them instead of the Hardwired control circuit constituted by the traditional relaycontact ones. When the pump driver is in error, the alarm will be touched off at the same time. If this alarm be kept for some times, the system will be shut down. After analyze the crafts of the system carefully, the request and the plan were worked out. This Paper contains the design of the software and the hardware for the system, and achieve the logical, safety control, fault measurement and the key for every alarm of it. At the same time, the automation and the intelligent of the control of the pump and the valve has been achieved in this paper. Lower the plication level of the Electrical Control System. Higher the degree of automation and the reliability of the system. After the Simulation in the lab, our system is reliable. Key Words: Drainage, PLC, Sequence control,Standby 目 錄 摘 要 I Abstract II 1 緒論 1 研究背景 1 國內研究現狀 1 設計的目的及意義 2 2 2 系統工藝設計 4 系統控制的主要功能 4 4 3系統整體控制方案的選擇 6 6 6 主流控制系統 6 PLC 與其他工業控制系統的比較 6 系統控制方案的確定 8 4系統硬件的設計 10 10 PLC 的選型 10 擴展模塊的選擇 11 傳感器的選擇 12 閥門的選擇 12 泵的選擇 14 電機的選擇 15 接觸器的選擇 15 過載保護裝置 15 17 系統配電圖 17 電機控制線路圖 18 控制器外部接線