宏達振動電機中英文對照說明書-wenkub
2022-11-11 04:00:49 本頁面
【正文】 not wash it in water. 2. 當海拔與環境溫度均符合要求時，振動電機定子繞組的溫度升限值（電阻法）為 80C。the oil mass for the two rank motor is half than bearing’s cubage, the oil mass for the four or six rank motor is twopart than bearing’s cubage. B. 電機運行 46月小修一次，運行一年大修一次，小修清除機體的積塵、污垢，檢查電機繞組的絕緣電阻、接頭、地線、連接部位的緊固螺栓是否松動，及時排除隱患。 storing and transporting process must not convert or collide the motor. 。 b. After the motor works for foursix months , it should be easy serviced. After one year, it should be heavy repaired. Easy servicing conclude cleaning dust over the shell, checking the insulating resistance in the motor winding, terminal, groundwire, the binding bolt in nterconnecting piece, to exclude hidden trouble in time. Heavy repairing must check the degree of wear of bearing, and the insulated status of winding. Change the bearing and winding in time. 六．常見故障及處理方法 6. error and processing method 序號 Number 故障現象 Symptom 造成故障的可能原因 Cause for the error 處理方法 Processing metheod 一 電源接通后，振動電機不能轉動 After plugging in, vibrating motor dose not work. 定子繞組相間短路，接地以及定子繞組斷路 定子繞組接線錯 ?BR 負載過重或有卡阻現象 1. stator winding has been short, earthing or turnoff. 2. stator winding has been wired error. 3. overload or locking. a) 檢查找出斷路、短路 接地部位，實行修復 b) 檢查定子繞組接線，加以糾正 c) 減輕負荷或清除卡阻物 a) check the stator winding for short,earthing or turnoff. b) Check stator winding’s wiring. c) Light load or clean the locking. 二 電機運行時轉速低于額定值 When the motor is working, rotate speed is below rating speed. 電機轉子斷裂 The rotor of motor is ruptured. 更換鑄鋁轉子 Change the cast aluminium rotor 三 支架腿斷裂 The leg of bracket is r支架腿斷裂 The leg of bracket is ruptu
公司管理相關推薦
鄂ICP備17016276號-1