【正文】 101. Which of the following are true regarding the mand output shown in the display? (Choose two.)A. There are at least two routers participating in the RIP process.B. A ping to will be successful.C. A ping to will be successful.D. RtrA has three interfaces participating in the RIP process.Answer: AC102. What three pieces of information can be used in an extended access list to filter traffic? (Choose three.)A. protocolB. VLAN numberC. TCP or UDP port numbersD. source switch port numberE. source IP address and destination IP addressF. source MAC address and destination MAC addressAnswer: ACE103. Refer to the exhibit. Which two statements are true about interVLAN routing in the topology that is shown inthe exhibit? (Choose two.)A. Host E and host F use the same IP gateway address. B. Router1 and Switch2 should be connected via a crossover cable.C. Router1 will not play a role in munications between host A and host D. D. The FastEthernet 0/0 interface on Router1 must be configured with subinterfaces.E. Router1 needs more LAN interfaces to acmodate the VLANs that are shown in the exhibit. F. The FastEthernet 0/0 interface on Router1 and Switch2 trunk ports must be configured using the same encapsulation type.Answer: DF104. What is the effect of using the service passwordencryption mand? A. Only the enable password will be encrypted.B. Only the enable secret password will be encrypted.C. Only passwords configured after the mand has been entered will be encrypted.D. It will encrypt the secret password and remove the enable secret password from the configuration.E. It will encrypt all current and future passwords.Answer: E105. Refer to the exhibit. For what two reasons has the router loaded its IOS image from the location that is shown? (Choose two.)A. Router1 has specific boot system mands that instruct it to load IOS from a TFTP server.B. Router1 is acting as a TFTP server for other routers. C. Router1 cannot locate a valid IOS image in flash memory.D. Router1 defaulted to ROMMON mode and loaded the IOS image from a TFTP server.E. Cisco routers will first attempt to load an image from TFTP for management purposes.Answer: AC106. At which OSI layer is a logical path created between two host systems? A. sessionB. transportC. networkD. data link E. physical Answer: C107. What functions do routers perform in a network? (Choose two.) A. packet switchingB. access layer securityC. path selection D. VLAN membership assignmentE. bridging between LAN segmentsF. microsegmentation of broadcast domainsAnswer: AC108. Refer to the exhibit. The show vtp status mand is executed at a switch that is generating the exhibited output. Which statement is true for this switch?A. The switch forwards its VLAN database to other switches in the ICND VTP domain.B. The configuration revision number increments each time the VLAN database is updated.C. The switch forwards VTP updates that are sent by other switches in the ICND domain. D. The VLAN database is updated when VTP information is received from other switches.Answer: C109. A Cisco router is booting and has just pleted the POST process. It is now ready to find and load an IOS image. What function does the router perform next?A. It checks the configuration register.B. It attempts to boot from a TFTP server.C. It loads the first image file in flash memory.D. It inspects the configuration file in NVRAM for boot instructions. Answer: A110. Refer to the exhibit. The output that is shown is generated at a switch. Which three of these statements are true? (Choose three.)A. All ports will be in a state of discarding, learning, or forwarding.B. Thirty VLANs have been configured on this switch. C. The bridge priority is lower than the default value for spanning tree. D. All interfaces that are shown are on shared media.E. All designated ports are in a forwarding state.F. This switch must be the root bridge for all VLANs on this switch.Answer: ACE111. What is the function of the mand switchport trunk native vlan 999 on a Cisco Catalyst switch?A. It creates a VLAN 999 interface.B. It designates VLAN 999 for untagged traffic.C. It blocks VLAN 999 traffic from passing on the trunk.D. It designates VLAN 999 as the default for all unknown tagged traffic.Answer: B112. Refer to the exhibit. After a RIP route is marked invalid on Router_1, how much time will elapse before that route is removed from the routing table?A. 30 seconds B. 60 seconds C. 90 seconds D. 180 seconds E. 240 secondsAnswer: B113. When a new trunk is configured on a 2950 switch, which VLANs by default are allowed over the trunk link?A. no VLANs B. all VLANsC. only VLANs 1 64D. only the VLANs that are specified when creating the trunkAnswer: B114. Which three statements describe the differences between RIP version 1 and RIP version 2? (Choose three.)A. RIP version 1 broadcasts updates whereas RIP version 2 uses multicasts.B. RIP version 1 multicasts updates while RIP version 2 uses broadcasts.C. Both RIP version 1 and RIP version 2 are classless routing protocols. D. RIP Version 2 is a classless routing protocol whereas RIP version 1 is a classful routing protocol.E. Both RIP version 1 and version 2 support authentication.F. RIP version 2 sends the subnet mask in updates and RIP version 1 does not.Answer: ADF 115. An access list was written with the four statements shown in the graphic. Which single access list statement will bine all four of these statements into a single statement that will have exactly the same effect?A. accesslist 10 permit B. accesslist 10 permit C. accesslis