裝配圖的表達方法ppt課件(已修改)
2025-04-03 01:31 本頁面
【正文】 Representation Methods of Assembly Drawings 裝配圖的表達方法裝配圖的表達方法General representation一般表達方法一般表達方法Conventional representation 規定畫法規定畫法 Special representation 特殊畫法特殊畫法 Simplified representation簡化畫法簡化畫法 請點擊相應標題顯示其內容請點擊相應標題顯示其內容General representation 一般表達方法一般表達方法 All the abovementioned representations are applied to the assembly drawing, including views, sectional views, cuts, and simplified representations. 前面所介紹的各種表達方法均適用于裝配圖，包前面所介紹的各種表達方法均適用于裝配圖，包括：視圖、剖視、斷面、簡化畫法等。括：視圖、剖視、斷面、簡化畫法等。請請點點擊擊鼠鼠標標左左鍵鍵顯顯示示后后面面內內容容Conventional representation 規定畫法規定畫法 If the screwed fastening piece and solid piece are longitudinally sectioned and the cut plane goes through the center of symmetry, these parts are represented as though they were not sectioned. 對于螺紋緊固件及實心件若按縱向剖切且剖切對于螺紋緊固件及實心件若按縱向剖切且剖切平面通過其對稱中心時，這些零件按不剖畫出。平面通過其對稱中心時，這些零件按不剖畫出。 Section lines in two contiguous metal parts must be in opposite directions or unequally spaced, while section lines of the same part must be consistent in different views. 兩個相鄰金屬零件的剖面線應方向相反或間距不同，而同一零件的剖兩個相鄰金屬零件的剖面線應方向相反或間距不同，而同一零件的剖面線在各個視圖中應保持一致。面線在各個視圖中應保持一致。2. Representing contact surf
規章制度相關推薦
鄂ICP備17016276號-1