【正文】
學號: 常州大學 課程設計(論文) 題 目 某城市污水處理廠的工藝設計 學 生 學 院 專業班級 指導教師 專業技術職務 二 ○ 一五 年 七 月 II 某城市污水處理廠的工藝設計 摘 要: 本設計處理規模為 54954m179。/d,對該區居民、商業及一些小型企業的生活和部分生產廢水進行處理,污水從泵房經格柵到沉砂池,進入初沉池,曝氣池,二沉池,再進入消毒池,處理后的出水可達到所要求的 處理后要求 SS≤ 22 mg/L,BOD5≤ 20 mg/L,剩余污泥從二沉池排出進入濃縮池,再進入脫水機房,最后外運處置。本設計的主要內容包括對泵房、格柵、沉砂池、初次沉淀池、曝氣池、二沉池、濃縮池等主要構筑物進行詳細、系統的設計計算和說明,確定構筑物的工藝尺寸,主要設備選型,提出土建結構設計、電氣控制設計要求,結合地形和設計規范,對污水處理廠進行平面布置和高程布置,對污水處理廠的投資和運行費用進行估算。 關鍵詞: 生活污水 曝氣 濃縮 III Process design of a municipal wastewater treatment plant Abstract: The construction of this design is 50000 cubic meters per day, For the residential, mercial and some small businesses of life and part of the production waste water treatment, sewage from the pumping station by the grid to sink sand pool, enters the primary settling tank, aeration tank, secondary sedimentation tank, again into the pool disinfection, the treated effluent can reach the required processing requirements of SS is less than or equal to 22 mg / L, BOD5 less than or equal to 20 mg / L, surplus sludge from the secondary sedimentation tank enters concentration pond, then it is dehydrated, at last it is carried out of the plant. Themajor content of this design includes:the calculation and introduction of pump house,grille, grit chamber, oxidation ditch, secondary sedimentation tank, contact tank,sludge impoundmentin detail and systematically, the size design of the mainly constructs, the main equipment selection,design requirements in civil engineering structure and electric control,level assign and vertical assign are done according to the landform and design specification, estimation of investment and operation cost. Keywords: domestic Aeration Concentrate IV 摘要 Ⅰ 目次 Ⅲ 1 緒論 1 設計題目 1 設計依據 1 設計目的 1 設計步驟和方式 1 設計參考資料 1 設計原始資料 2 設計參數 2 設計水量計算 2 設計水質及處理程度計算 3 設計內容及要求 3 2 方案的確定 3 該城市西區生活污水特點 3 該城市污水處理的發展趨勢 4 城 市污水處理適用工藝技術選擇的原則 4 技術合理 4 經濟節能 4 易于管理 4 重視環境 4 城市污水處理技術