材料成型及控制工程專業(yè)畢業(yè)設計外文翻譯-文庫吧
2024-11-13 02:59 本頁面
【正文】 section” parts. This type of part can also cause serious die damage if double blanks occur.Cutting DiesTo reduce press tonnage requirements and extend die life, a minimum shear of four to six times metal thickness in twelve inches of trim steel length is remended.To reduce die maintenance, maximum trim angles should be about 5176。 to 10176。 less than those used for mild steel. Trim steels should be keyed or pocketed in casting to avoid flexing. Die clearance should be 7 to 10% of metal thickness.Drawbead Types Conventional Drawbeads Runout Drawbeads For . Lock Beads for StretchForm DieFigure 161. Providing a vertical step in the flange stiffens and straightens the flange, stopping sidewall curl as well as springback.2. The addition of stiffening darts helps maintain a 90degree flange.3. By adding a horizontal step along the flange, the flange is stiffened, resulting in reduced springback.4. Back relief on the upper flange steel allows for extra pressure to be applied futher out on the formed radius.Section 5 – Die Tryout Guidelines for High Strength Steel DiesGeneral Guidelines for Die TryoutDraw DiesHigher draw die binder pressure and press tonnage will be necessary in order to maintain process control and draw parts without buckles. A double action press or a press with hydraulic cushion may be required in some cases to achieve the required binder forces.HSS draw die operations will require sheet steel lubricants that are formulated for extreme pressures. Mill oils will not provide sufficient lubricity for most applications. Prelubes or dry film lubricants may be necessary for process control.Die plan view punchline corner radii should be larger than with mild steels to avoid buckling in the corners of the binder.Stretch Form DiesLock beads may require modification to avoid cracking or tearing with higher strength grades of HSS. Opening side walls of beads and enlarging corner radii will avoid cracking of high strength sheet steel. Lock beads should be continuous around the punchline for stretch form dies.For large panels from stretchform dies, such as a roof panel or hood outer, elastic recovery may result in a shrunken panel that does not fit well on the male die member of the trim or flange dies. This problem is corrected by adding a “plus” factor to the overall part dimensions of the draw die or stretch form die punch. This “plus” is usually no more tha
公司管理相關(guān)推薦
鄂ICP備17016276號-1