數控專業畢業設計外文翻譯--wincc在供熱站恒壓供水監控系統中的應用-數控設計(完整版)
【正文】 outlet channel of pressure sensor installation will export water pressure signals are converted to electrical signals, send PLC fuzzy inference operation, the output control signals to the converter, regulating the operation of pump motor speed, until the actual elimination of hydraulic pressure and set the deviation, constant voltage supply. Programmable controller can control pumps Kai stopped. When the system started working, inverter control from start on 1st pump frequency operation. If users increased consumption of the converter output frequency up to 50 Hz, the pressure will still be less than the set value, then after some time delay, on the 1st of the pump switching frequency operation。 Set time will lead to excessive speed converter running in the system bee regulate slow, delayed response, contingency ability is poor. Yi system at the state shortterm instability. To protect the converter is not tripping, the scene of many of them using converter increases deceleration time setting too long, the problems they bring very easily be the appearance of the normal equipment and hide, but the converter operating in lessthanoptimal state. So the scene when used according to the load driven by a different nature, testing out the permission of the shortest load increases deceleration time, setting. For the pump motor, plus deceleration time in the choice between seconds. 畢業設計（論文）外文翻譯 外文翻譯 Wincc 在供熱站恒壓供水監控系統中的應用 1. 恒壓供水基本工作原理 系統采用變頻調速方式自動調節誰笨點擊轉速或加、減泵?？刂茩C(jī)組運行、故障的自動停機和報警操作。若用戶用水量增加變頻器的輸出頻率上升到 50Hz 水壓仍達不到設定值，則將 2 號泵切換為工頻運行 。再根據極大極小推力合成規則求出輸出語言變量論域上的模糊集合 U： 最后對 U 采用加權平均法進行解模糊，將模糊量 U 轉換成精確量 u，上述 過程是離線進行的，最終得到模糊控制查詢表，如圖 2 所示。 變頻恒壓供水系統的參數選取 合理選取壓力控制參數，實現系統低能耗恒壓供水。對于水泵電機，加減速時間的選擇在 秒之間。兩者如何選擇，我們來簡單分析一下管網最不利點壓力恒定時。 程序設計 RSLogix5000 是支持 Logix5000 系統控制器的編程軟件，程序用梯形圖語言編寫，包括水泵啟動和切換主程序、 PI 控制子程序、模糊控制子程序和故障報警子程序，當采樣時間到時， PLC 采集水壓信號，并與給定信號比較得到誤差 e，若 e=e0(e0 為 PI 和模糊控制切換閥值 )，則進入 PI 控制子程序；若 ee0，則進入模糊控制子程序。繁殖托用戶用水量減少，則依照“先啟后?！痹瓌t一次將水泵切除 如此反復循環，實現系統的恒壓供水。在輸煤廊中控制給煤量和給煤速度，檢測給煤質量（煤的粉碎成都和含雜質 量）。調節器、壓力傳感器、液位傳感器、動力控制線路等組成，用戶通過上位監控系統或控制柜面板上的指示燈、按鈕、轉換開關來了解和控制系統的運行。畢業設計（論文）外文翻譯 外文原文 Wincc in heating supply stapply stations Constant Pressure Monitoring System Application onstant voltage supply basic working principle System uses Automatic Frequency Control regulation or pump motor speed. Plus or minus is primarily by the Frequency Control regulator,pressure sensors,liquid level sensor pow
畢業設計相關推薦
鄂ICP備17016276號-1