【正文】 Bytes of InSystem Reprogrammable Flash MemoryEndurance: 1,000 Write/Erase CyclesFully Static Operation: 0 Hz to 24 MHzThreelevel Program Memory Lock256 x 8bit Internal RAM32 Programmable I/O LinesThree 16bit Timer/CountersEight Interrupt SourcesProgrammable Serial ChannelLowpower Idle and Powerdown ModesDescriptionThe AT89C52 is a lowpower, highperformance CMOS 8bit microputer with 8K bytes of Flash programmable and erasable read only memory (PEROM). The device is manufactured using Atmel’s highdensity nonvolatile memory technology and is patible with the industrystandard 80C51 and 80C52 instruction set and pin out. The onchip Flash allows the program memory to be reprogrammed insystem or by a conventional nonvolatile memory programmer. By bining a versatile 8bit CPU with Flash on a monolithic chip, the Atmel AT89C52 is a powerful microputer which provides a highlyflexible and costeffective solution to many embedded control applications.Pin ConfigurationsBlock DiagramPin DescriptionVCCSupply voltage.GNDGround.Port 0Port 0 is an 8bit open drain bidirectional I/O port. As an output port, each pin can sink eight TTL inputs. When 1s are written to port 0 pins, the pins can be used as highimpedance inputs. Port 0 can also be configured to be the multiplexed loworder address/data bus during accesses to external program and data memory. In this mode, P0 has internal pullups. Port 0 also receives the code bytes during Flash programming and outputs the code bytes during program verification. External pullups are required during program verification.Port 1Port 1 is an 8bit bidirectional I/O port with internal pullups. The Port 1 output buffers can sink/source four TTL inputs. When 1s are written to Port 1 pins, they are pulled high by the internal pullups and can be used as inputs. As inputs, Port 1 pins that are externally being pulled low will source current (IIL) because of the internal pullups. In addition, and can be configured to be the timer/counter 2 external count input () and the timer/counter 2 trigger input (), respectively, as shown in the following table. Port 1 also receives the loworder address bytes during Flash programming and verification. Port 2Port 2 is an 8bit bidirectional I/O port with internal pullups. The Port 2 output buffers can sink/source four TTL inputs. When 1s are written to Port 2 pins, they are pulled high by the internal pullups and can be used as inputs. As inputs, Port 2 pins that are externally being pulled low will source current (IIL) because of the internal pullups. Port 2 emits the highorder address byte during fetches from external program memory and during accesses to external data memories that use 16bit addresses (MOVX DPTR). In this application, Port 2 uses strong internal pullups when emitting 1s. During accesses to external data memories that use 8bit addresses (MOVX RI), Port 2 emits the contents of the P2 Special Function Register. Port 2 also receives the highorder address bits and some control signals during Flash programming and verification.Port 3Port 3 is an 8bit bidirectional I/O port with internal pullups. The Port 3 output buffers can sink/source four TTL inputs. When 1s are written to Port 3 pins, they are pulled high by the internal pullups and can be used as inputs. As inputs, Port 3 pins that are externally being pulled low will source current (IIL) because of the pullups.Port 3 also serves the functions of various special features of the AT89C51, as shown in the following table. Port 3 also receives some control signals for Flash programming and verification.RSTReset input. A high on this pin for two machine cycles while the oscillator is running resets the device.ALE/Address Latch Enable is an output pulse for latching the low byte