【正文】
ason the decibels of sound are often indicated as dB re Pa. Lp = 10 lg (p22/p12) = 20 lg (p /p0) Comparison of Sound Pressure Level and Sound Pressure 聲功率和聲功率級 ? What is sound power? The sound power is the sound energy transferred per second from the noise source to the air. Power is expressed in units called watts (W). Like sound pressure, sound power (in W) is usually expressed as sound power levels in dB. Lw=10 lg (W/W0) 聲強和聲強級 LI=10 lg (I/I0) Comparison of Sound Power level and Sound Power 聲壓、聲強和聲功率的關系 ? 聲壓(級)、聲強(級)和聲功率(級)的關系見 P187,圖 71 噪聲的頻率和聽覺 ? 聲源在單位時間內的振動次數稱為聲的頻率,單位為 Hz。環境影響評價 第七章 噪聲環境影響評價 ? 噪聲和噪聲評價量 ? ? What are sound and noise? Sound is what we hear. Noise is unwanted sound. The difference between sound and noise depends upon the listener and the circumstances. Rock music can be pleasurable sound to one person and an annoying noise to another. In either case, it can be hazardous to a person39。頻率高,音調高,頻率底則音調低。 The most widely used sound level filter is the A scale, which roughly corresponds to the inverse of the 40 dB (at 1 kHz) equalloudness curve. Using this filter, the sound level meter is thus less sensitive to very high and very low frequencies. Measurements made on this scale are expressed as dBA. ? 等效連續 A聲級: 考慮了某一段時間內的噪聲隨時間變化的特性,用能量平均的方法并以一個 A聲級值去表示該段時間內的噪聲大小。 噪聲環境影響評價工作等級劃分的基本原則 ? 對于 大、中型建設項目 ,屬于規劃區內的建設工程,或受噪聲影響的范圍內有適用于 GB309693規定的 0類標準及以上 的需要特別安靜的地區,以及對噪聲有限制的保護區等噪聲敏感目標;項目建設前后 噪聲級有顯著增高 (噪聲級增高量達5~10dBA)或受 影響人口顯著增多 的情況,應按 一級 評價進行工作。 ? 3類標準適用于工業區。 ? Ⅲ 類標準適用于工業區。 評價工作范圍 ? 噪聲環境影響的評價范圍一般根據工作等級確定 ? 對于包含多個呈現點聲源性質的擬建項目(如工廠、港口、施工工地、鐵路的占場等),該項目邊界往外200m內的評價范圍一般能滿足一級評價的要求;相應的二級和三級評價的范圍可根據實際情況適當縮小。 ? 獲得噪聲源數據有兩個途徑: 類比測量法 和引用已有的數據,包括國外的資料。測量時,將聲級計置于慢檔,每個測點讀取 5個 A聲級值,取算術平均值為測定值。如廠界有圍墻,測點應高于圍墻。同時記錄車流量。 為了便于繪制等聲級線圖,可以用往格法確定預測點。 公路評價要點 ? 建設項目概況與工程分析 ? 工程概況(地理位置、路線起點與終點、原有公路概況及存在的問題 [不一定有 ]、預測交通量、建設標準與規模、路線方案選擇與推薦意見) ? 工程內容(技術指標與技術工程數量、筑路材料與消耗量、路基工程、路面工程、橋梁涵洞、交叉工程、沿線設施、工期安排) ? 投資概況 ? 拆