電氣開關電源外文文獻-全文預覽
【正文】 r switches, and overcurrent protection must be converted to pulse output mands to control the modulator to protect the transistor switch. In order to achieve overcurrent protection are generally required sampling resistor in series in the circuit, this will affect the efficiency of power supply, so more for lowpower switching regulator of occasions. In the highpower switching power supply, by taking into account the power consumption should be avoided as far as possible access to the sampling resistor. Therefore, there will usually be converted to overcurrent protection, and undervoltage protection. overvoltage protection Switching regulator39。s output voltage, the lower limit of the output is off, due to the voltage value of voltage protection. Overcurrent protection can be based on the maximum output current to determine. False alarm in order not to protect the value of a certain margin to remain appropriate. 3) from the above two methods to determine the protection after the power supply device in accordance with the needs of measures to determine the alarm. Measures the general alarm sound and light alarm two police. Voice of the police applied to more plex machines, power supply parts and do not stand out in a place, it can give staff an effective warning of failure。 load shortcircuit output voltage will also decline. Especially in the reversedphase stepup or stepup switching regulator DC voltage of the protection due to overcurrent protection with closely related and therefore more important. Implementation of Switching Regulators in the termination of the output voltage parators.Normally, there is no parator output, once the voltage drops below the allowable value in the parator on the flip, drive alarm circuit。s input overvoltage protection, including overvoltage protection and output overvoltage protection. Switching regulator is not used in DC power supply voltage regulator and rectifier, such as battery voltage, if too high, so switching regulator is not working properly, or even damage to internal devices, therefore, it is necessary to use the input overvoltage protection circuit. In the circuit, when the input DC power supply voltage higher than the voltage regulator diode breakdown voltage value, the breakdown voltage regulator tube, a current flowing through resistor R, so that V turnon transistor, relay, normally closed contact off open, cut off the input. Voltage regulator voltage regulator which controls the value of Vz = ESrmaxUBE. The polarity of input power with the input protection circuit can be bined with overvoltage protection, polarity protection constitute a differential circuit and overvoltage protection. Output overvoltage protection switching power supply is essential. In particular, for the 5V output of the switching regulator, it is a lot of load on a high level of integration of the logic device. If at work, switching regulator sudden damage to the switch transistor, the output potential may be increased immediately to the importation of non
公司管理相關推薦
鄂ICP備17016276號-1