外文翻譯---液壓密封完整性調查研究-液壓系統-全文預覽
【正文】 ce on Fluid Power, Tampere, Finland, May 26–28, 1999, pp. 51–64. [4] J. Watton, Condition Monitoring and Fault Diagnosis in Fluid Power Syste ms, Ellis Horwood, New York, USA, 1992. [5] . Le, J. Watton, . Pham, An artificial neural work based approach to fault diagnosis and classification of fluid power systems, Proceedings of the Institution of Mechanical Engineers, Part I, Journal of Systems and Control Engineering 211 (1997) 307–317. [6] . Le, J. Watton, . Pham, Fault classification of fluid power system using a dynamics feature extraction technique and neural works, Proceedings of the Institution of Mechanical Engineers, Part I, Journal of Systems and Control Engineering 212 (1998) 87–97. [7] G. Thompson, G. Zolkiewski, An experimental investigation into the detection of internal leakage of gases through valves by vibration analysis, Proceedings of the Institution of Mechanical Engineers, Part E, Journal of Process Mechanical Engineering 211 (1997) 195–207. [8] M. Pietola, R. Ma168。 Root mean square。機電 工程學院 機械系機械設計制造及其自動化班 學生 毛祖慶 畢業設計 第 1頁 共 13頁 井岡山大學外文翻譯用紙 Mechanical Systems and Signal Processing, 2020, 21: 1115–1126 A study of hydraulic seal integrity P. Chena, . Chua, . Lim Abstract: The work described in this paper involved online detection of seal defects in a water hydraulic cylinder. An obvious effect of seal defect is internal leakage. Therefore, the approach used was to detect the internal leakage using suitable technique. The technique used involved detecting the acoustic emission (AE) due to the internal leakage. This paper evaluated various parameters of AE signals in terms of their capability in estimating the internal leakage rate in a water hydraulic cylinder. Experiments were carried out to study the characteristics of AE parameters at different internal leakage rates, the parameters including the rootmeansquare (rms) value, the count rate, the peak magnitude of power spectral density and the energy. The correlations between these parameters and the internal leakage rate were analysed carefully. The results show that energybased AE parameters, especially the rms value, are more suitable to interpret AE signals generated by internal leakage. Keywords: Acoustic emission。 AE count rate。 then, the simulation of the leakage is presented. In order to simulate scores created by the abrasive action of solid particulates, a file was used, in the present work, to make scores on the piston seal surfaces of a water hydraulic cylinder. Fig. 2 shows the scored piston seals used in the experiments. These seals lead to an internal leakage smaller than L/min for the pressure range of 0–70 bar. Sixteen scores were equally distributed along the circumference of the seals. The dimensions of these scores were measured with a noncontact optical measurement system. shows the profile of a score taken by the measurement system. Along the edge of the score, five key points were selected and their coordinates were measured. The width and depth of the score were then measured. In addition, a circular arc fit to these five points was calculated. Thus, an approximate radius of the score could be obtained. Fig. 2. The 16score piston seals. Fig. 3. The profile of a score. 機電 工程學院 機械系機械設計制造及其自動化班 學生 毛祖慶 畢業設計 第 5頁 共 13頁 井岡山大學外文翻譯用紙 4. Experimental results In the experiment, 100 sets of data were acquired at different internal leakage rates, with each set consisting of 40 records of AE signals measured at a certain leakage rate. Each record of AE signal contained 4096 points sampled at 5 MHz, from which AE parameters were calculated. Fo
畢業設計相關推薦
鄂ICP備17016276號-1