外文翻譯---基于labview的電流互感器校驗儀(已修改)
2025-06-18 22:31 本頁面
【正文】 附錄 A LabVIEW Based Instrument Current Transformer Calibrator Xin Ai Hal Bao . Song 1) North China Electric Power University, Beijing, China 107206 2) Brunel University. UK ABSTRACT The Virtual Instrument (VI) mainly refers to build all kinds of instruments by software such as LabVIEW, which likes a real instrument build in a puter. Its39。 main characteristics are flexibility, multifunctions, multiple uses for one PC puter, giving high performance, and is less costly. In this paper, the VI technology is applied to the test and measurement of instrument current transformer (TA). By using the LabVIEW, the TA accuracy calibrator was developed. This virtual calibrator can automatically measure the accuracy of and can indicate the ratio error and phase error curves. The tests and calibration for the TA show that the virtual TA calibrator can be used in place of the traditional calibrator and is much better than the traditional one. Keywords： Instrument current transformer (TA), TA calibrator, Virtual Instruments, LabVIEW. I. INTRODUCTION Since 1992 the VXIbus standard was established by the United States and LabVIEW was presented by the National Instruments co.(Nl), the Virtual Instrument (VI) have lain the foundation for its mercial use. The main characteristic of Virtual Instrument is that it makes instruments by software. Most of the traditional instrument can be developed by VI. The VI is a real instrument made by the personal puter. The Instrument current transformer (TA) is widely used in all kinds of current measurement and it has the functions of protection, isolation and extending the measuring range. With the rapid development of puter measurement and control technology, and with the sequent emergence of current transformer and transducer, there is an increasing number of current transformers with high accuracy and low secondary current. The standard TA secondary current is usually 1A or 5A: some nonstandard TA secondary current may be 0 1A or lower. Although we have the technique to make this kind of calibrator by means of hardware such as single chip puter and electronic circuit, DSP and so on, it will cost too much money for these nostandard calibrator and will take too much time and the calibrator made by these hardware mill not be satisfactory in both function and practicality for designing all kinds of new TA. The calibrator that adopts VI technology not only can meet the requirements of the traditional one but also can satisfy customers with such advantages as multifunctions, convenience, and high ratio between performance and cost. The experiment results indicate that the virtual calibrator can provide excellent condition for TA measurement and design. The VI technology and personal puter must be widely used in the area of calibration on instrument transformer. Ⅱ . THE WORKING PRINCIPLE OF TA CALIBRATOR The error of TA includes ratio error and phase error. The measuring of the error of TA or the calibration of the accuracy of TA usually applies differential measuring method. The method needs a standard TA except the measured TA and a TA calibrator. There is the same turn ratio between the standard and measured T4 and the standard TA39。s accuracy should be 2 levels higher than the measured one. The calibrator function lies in forming parison circuits, measurin
畢業設計相關推薦
鄂ICP備17016276號-1